loose wire coming out of PCM... what's it for?
#1
Teching In
Thread Starter
Join Date: Sep 2007
Location: Edmonton, Alberta,
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
loose wire coming out of PCM... what's it for?
Hey guys I was cleaning up my PCM harness wiring. I have a h/c/i/e 2001 LS1 swapped into a Mazda RX7. Anyway as i was cleaning up some wires and removing ones i didn't need I came across this one wire coming out of the red PCM plug
pin 53 GRA/BLK circuit no. 1687 spark Retard Signal
can anybody tell me what it's for? if i need to wire it back into something or if its not important... when i took all the loom/electrical tape of my harness it was just loose in there not connected to anything
thanks,
-Jeff
pin 53 GRA/BLK circuit no. 1687 spark Retard Signal
can anybody tell me what it's for? if i need to wire it back into something or if its not important... when i took all the loom/electrical tape of my harness it was just loose in there not connected to anything
thanks,
-Jeff
#5
TECH Senior Member
What the 2 previous posters said...
That's how the traction control function in the EBCM requests the PCM to reduce ignition timing (i.e. to reduce engine torque output).
That's how the traction control function in the EBCM requests the PCM to reduce ignition timing (i.e. to reduce engine torque output).
#6
Teching In
Thread Starter
Join Date: Sep 2007
Location: Edmonton, Alberta,
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
alright thanks guys! just wanted to make sure it was nothing important. I don't have the traction control system in my swap so i dont need to worry about t