OBD II not working
06-10-2010, 11:09 AM
#1
TECH Enthusiast
Thread Starter
iTrader: (5)
Join Date: Jun 2006
Location: Long Beach MS/Birmingham AL
Posts: 641
Received 0 Likes
on
0 Posts
OBD II not working I had my car tuned about a month ago (not the first time tuned by this tuner), and the car has an SES light on. I assume that it is a lazy 02. Well, I have tried to scan it with two different scanners, and the scanners will not come when hooked up. The only thing that has changed is that my shifter cable (a4) broke, and I put a new one in. I did notice that the gear indicator is not right (in drive in N, r is between P and n, etc), and when it park it will roll
06-10-2010, 11:29 AM
#2
LS1Tech Sponsor
the obd port is usually powered by the cig lighter fuse or an aux. power port fuse...
so, check your fuses...
so, check your fuses...
__________________
06MonteSS / DiabLew Tune
2014 Camaro 2SS/RS - LS3, 6-speed manual, short-throw performance shifter, NPP dual-mode performance exhaust, 1LE front splitter, ZL1 rockers, Z28 Rear Spoiler, all paint-matched Red Rock Metallic, BMR strut tower brace, Cold Air Inductions cold air intake, Apex Motorsports, Inc. catch-can, Custom DiabLew Tune
www.diablewtune.com -- www.diablocustomtune.com -- www.diablocustomtunegm.com
06MonteSS / DiabLew Tune
2014 Camaro 2SS/RS - LS3, 6-speed manual, short-throw performance shifter, NPP dual-mode performance exhaust, 1LE front splitter, ZL1 rockers, Z28 Rear Spoiler, all paint-matched Red Rock Metallic, BMR strut tower brace, Cold Air Inductions cold air intake, Apex Motorsports, Inc. catch-can, Custom DiabLew Tune
www.diablewtune.com -- www.diablocustomtune.com -- www.diablocustomtunegm.com
