Can't read/connect through OBDII port now
10-05-2010, 04:56 PM
#1
11 Second Club
Thread Starter
iTrader: (2)
Join Date: Aug 2010
Posts: 238
Likes: 0
Received 0 Likes
on
0 Posts
Can't read/connect through OBDII port now 98 Z28.
I have a handheld scanner that I used to connect to my car and pull codes/clear codes. I never had any problems reading before, and it reads on other vehicles.
What would cause the scanner not to read now?
I did have the computer unconnected so I could solder wires into my progressive controller (TPS and RPM).
The SES light is on and I can't read it to pull codes.
Any ideas?
I have a handheld scanner that I used to connect to my car and pull codes/clear codes. I never had any problems reading before, and it reads on other vehicles.
What would cause the scanner not to read now?
I did have the computer unconnected so I could solder wires into my progressive controller (TPS and RPM).
The SES light is on and I can't read it to pull codes.
Any ideas?
