superdylan

Hi,
I'm pretty new to the programming side of this, so please don't flame!

I've done an engine swap with a 5.3L (L59) FlexFuel engine. The engine was originally attached to an automatic transmission vehicle. It's now mated to my Toyota 5-speed manual.

I've got HPTuners hooked up and I'm looking at the tables and I'm trying to figure out which tables are valid and which tables my PCM will never see.

Here's the situation...I've wired up the PCM harness and everything for the 5-speed. I have the wiring set to see the engine in NEUTRAL gear. (I don't know if this is a good or bad thing. I just figured that the PCM can't possibly tell what gear my 5-speed is in.)

Could someone tell me what tables I can use to tune the engine? What tables are used for a manual transmission?

minytrker

iTrader: (13)

Just do a full flash to a manual tune with your same engine.

Rauch

Exactly. Just find a factory binary for your vehicle in a 5-speed. From there, just flash it over, and it should work fine.

Now if you have any sort of performance tune, that could be more of an issue.

superdylan

I don't know of any manual transmission Gen III 5.3L trucks. Could someone please shed some light on this? My original engine was pulled from a 2007 Chevy Silverado Classic. It's a DBW setup and was originally mated to a 460LE.

AFAIK, no Chevy Silverado sold in America came with a manual transmission. Any more ideas?

CalEditor

iTrader: (1)

What software do you have?

superdylan

I have HPTuners to program files. I looked at the HPTuners website bin directory and there was no manual transmission bin for a 5.3L engine. Am I missing something?

CalEditor

iTrader: (1)

PM me your VCM ID and the segment info and I will give you a manual trans calibration that will allow you not to use anymore credits

minytrker

iTrader: (13)

There were some sold with manual's, my brother and one of his friends have manuals. I could do the segment swap for you if you had EFI Live. I can't do with HPT. I don't have the tune database in HPT format as I do with EFI. Email HPT support, I think they can do the segment swap for you.

CalEditor

iTrader: (1)

I have one
I just need the info so I can make a good bin file