marthastewart

iTrader: (1)

So I got it to run and start up good with no ac. if the ac is on when I start it it fumbles a little then dies. have to keep the foot on the gas to keep it running. Once I get moving it runs great and no more problems. What should I be looking at? I dialed in the RAF and dont think the RAF needs to be messed with since its running/idling great without the A/C turned on. What table can I adjust to give me more air only when its hot and ac being on? I am using HP Tuners.

ghost-1

iTrader: (4)

under idle/airflow I have my max in gear max is .132 and min is -.397, ac offset max/in gear set to .066 and my ac offset filt at .0050

Hope this helps.

marthastewart

iTrader: (1)

So if mine is set to -.50 min and 4.50 max then mine should be even higher and allowing more air right? Or am I misunderstanding this table?