Ghettosmirf

ok iv been chasing this problem for a while now. my car runs like poo. at first it would only die when i turn on the fan so i checked all the grounds(from all the ones i seen they were fine but i could be missing some idk) Then i remembered i just installed an ud pully on the crank so i needed a smaller alt pully. Car still ran like poo. So today i put a code reader on her and this is everything it said:
p0101
p0102
p0103
p0480
p0481
mil on
moniters
3 inc
catlyst
sec air
02 sensor
5 ready
fuel
misfire

I dont have rear o2 sensors or cats. before reseting all the codes it would still run and drive just not healthy, now that there reset the car wont run barely at all unless im giving it gas then it will die.

Any ideas?

stangtrader

iTrader: (2)

3Of your codes are maf codes the other two are cooling fan relay codes. Have you made sure your maf is pluged in? Checked th engine sensor fueses? Fans working?

Ghettosmirf

the fan is also no longer stock im running a toggle right now and i have a thermostat switch for the fan when I get the car running good. im sorry im tired and cant think whats the maf. mas air flow? If so yes it is but my intake is all ls6.