Crank position sensor relearn
06-30-2004, 11:53 AM
#1
TECH Enthusiast
Thread Starter
Join Date: Apr 2003
Location: silver Spring MD
Posts: 561
Likes: 0
Received 0 Likes
on
0 Posts
Crank position sensor relearn Hi Guys
I have question - I replaced my Cam and have been tuning my PCM (slowly). I was reading some old postings and somebody stated that you should perform a Crank position sensor relearn after replacing the Cam and doing tuning. When I have not done that and was wondering if I should do it or leave well enough along?
Thanks
Bill
I have question - I replaced my Cam and have been tuning my PCM (slowly). I was reading some old postings and somebody stated that you should perform a Crank position sensor relearn after replacing the Cam and doing tuning. When I have not done that and was wondering if I should do it or leave well enough along?
Thanks
Bill
06-30-2004, 04:26 PM
#2
12 Second Club
iTrader: (13)
Join Date: Nov 2001
Location: San Diego, CA
Posts: 1,898
Likes: 0
Received 0 Likes
on
0 Posts
The ECM will let you know if it can't learn the crank position - it will throw a code P1336 "Crankshaft Position System Variation Not Learned".
If you have no code, you shouldn't need to worry.
BTW - only a Tech II tool (dealer) or newer verions of EFILive software can do the CASE relearn as far as I know.
Normally it only needs to be done when replacing the PCM or the crank reluctor/sensor.
Bad30th
If you have no code, you shouldn't need to worry.
BTW - only a Tech II tool (dealer) or newer verions of EFILive software can do the CASE relearn as far as I know.
Normally it only needs to be done when replacing the PCM or the crank reluctor/sensor.
Bad30th
06-30-2004, 06:00 PM
#3
TECH Regular
Join Date: Apr 2003
Location: Atlanta, GA
Posts: 413
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Bad30th
The ECM will let you know if it can't learn the crank position - it will throw a code P1336 "Crankshaft Position System Variation Not Learned".
If you have no code, you shouldn't need to worry.
BTW - only a Tech II tool (dealer) or newer verions of EFILive software can do the CASE relearn as far as I know.
Normally it only needs to be done when replacing the PCM or the crank reluctor/sensor.
Bad30th
If you have no code, you shouldn't need to worry.
BTW - only a Tech II tool (dealer) or newer verions of EFILive software can do the CASE relearn as far as I know.
Normally it only needs to be done when replacing the PCM or the crank reluctor/sensor.
Bad30th
