using hp tuners for a window switch
12-15-2004, 01:23 PM
#1
11 Second Club
Thread Starter
iTrader: (16)
Join Date: May 2004
Location: MS
Posts: 2,223
Likes: 0
Received 0 Likes
on
0 Posts
using hp tuners for a window switch I read a while back this could be done w/ the new interface. i was just wondering if anyone is doing it and how it can be done.
12-15-2004, 01:33 PM
#2
TECH Senior Member
http://www.hptuners.com/products.html
Check out the user manual
Under Connecting to the Vehicle, Driving Relays
Unfortuanetly I'm not very good at reading wiring diagrams... Later I'll grab a relay and post up how I would do it... (I would wire the 2 12 volts , 1 switched 1 battery, then have the output pin of the Relay feeding the +12 volt for the device, and have HP Tuners control the ground... so the relay becomes ground activated.. HPT sends ground... relay then sends +12 to device)
Check out the user manual
Under Connecting to the Vehicle, Driving Relays
Unfortuanetly I'm not very good at reading wiring diagrams... Later I'll grab a relay and post up how I would do it... (I would wire the 2 12 volts , 1 switched 1 battery, then have the output pin of the Relay feeding the +12 volt for the device, and have HP Tuners control the ground... so the relay becomes ground activated.. HPT sends ground... relay then sends +12 to device)
