Pavetim

iTrader: (15)

I have an 02 WS6 and was wondering if you know where I could tap into the output wire for the MAP sensor so I can hook it up to my Innovate wideband? Thanks.

WS6FirebirdTA00

iTrader: (33)

might have to pull it off the pcm, not sure the pin though

Pavetim

iTrader: (15)

Thats where I hope to pull it off of since can't get at the sensor. But I need to know what pin. But thanks anyways.

WS6FirebirdTA00

iTrader: (33)

ill see if i can find anything in this book i have, if i do ill post back up

Pavetim

iTrader: (15)

Think i got it, found couple diagrams. But if you find anything let me know just as a double check. Thanks.

Pavetim

iTrader: (15)

Ok pretty sure I got it but there are 3 wires the MAP sensor signal, low reference, and 5V reference. You know what one i'd use? I'm guessing the map sensor signal but not sure

WS6FirebirdTA00

iTrader: (33)

i know on my shift light they mentioned it had to be modified for a 5v signal , im not good with electrical but i would think it woud be the 5v ref or the signal (of course the signal would make sense if that is the output for the map value)

jimmyblue

iTrader: (11)

Red 32 Lt Grn MAP Sensor Signal

Believe MAP is straight line, 0.25V at 20kPa
to 4.85V at 102kPa. For regular Delphi 1-bar
ones anyway.

Pavetim

iTrader: (15)

Sweet thanks alot guys this just might save me $150 instead of getting the hptuners eio upgrade.

97c5

iTrader: (1)

Jimmy,
Do you know the pin out for the 97-98 pcm. Thanks.

97c5

iTrader: (1)

ttt...