LS1BlackBird99

iTrader: (202)

I have my 02 bung welded into the passenger side header. What is the exact route I should run the wires up into the car? Anyone have any pointers or a write up?

MeentSS02

iTrader: (11)

I don't know on the passenger side, as I run mine on the driver's side. I just found a rubber grommet that sits underneath the floor mat, and took the wires in through that. I pulled the carpet, and ran the wires towards the shifter to get them out from under the carpet, and went from there. My SLP subframe connectors gave me a nice shelf on top of the front cross brace to zip tie it in place out of the way.

Installing the damn thing was harder than getting my car tuned

muncie21

iTrader: (14)

I've heard of some people going through the shifter hole in tunnel.

ringram

Yep, up over trans, inside the shifter boot and LC1 hidden in the console.

bshell

iTrader: (24)

That's how I run mine, very well hidden and you can still pull the shifter boot from the console to unplug the sensor to perform a free air cal.