using atap
06-22-2006, 02:08 PM
#1
Launching!
Thread Starter
Join Date: Jul 2005
Location: Sweden (Malmö)
Posts: 279
Likes: 0
Received 0 Likes
on
0 Posts
using atap I have a autotap and i want to see that everything is ok with the car. What parameters should i look at? And what should they be at? What else can you do?
I have mafends and a maft + catback and lid
I have mafends and a maft + catback and lid
07-01-2006, 03:10 AM
#3
Launching!
Thread Starter
Join Date: Jul 2005
Location: Sweden (Malmö)
Posts: 279
Likes: 0
Received 0 Likes
on
0 Posts
2.04 version. So if i want to check the tune on the car. What should i look at?
would be greatly apperciated if anyone could tell me how to do, and i dont really understand how to read the numbers....
would be greatly apperciated if anyone could tell me how to do, and i dont really understand how to read the numbers....
Last edited by Doski; 07-01-2006 at 03:45 AM.
07-03-2006, 03:38 PM
#4
Launching!
Thread Starter
Join Date: Jul 2005
Location: Sweden (Malmö)
Posts: 279
Likes: 0
Received 0 Likes
on
0 Posts
anyone...please. I drove a little yesterday but i dont understand the loggdata.
only thing i know is that o2 should be 890mv at wot. i think mine showed 40???
only thing i know is that o2 should be 890mv at wot. i think mine showed 40???
Last edited by Doski; 07-04-2006 at 04:40 AM.
07-04-2006, 06:39 AM
#6
TECH Junkie
iTrader: (28)
Join Date: Jan 2004
Location: Houston
Posts: 3,250
Likes: 0
Received 0 Likes
on
0 Posts
it's been a while since i played with atap. you might try logging fewer parameters. IIRC, ataps sample rate reduces dramatically with each additional parameter selection.
In otherwords, if you had just a quick WOT, atap may not be scanning fast enough to capture the WOT run.
In otherwords, if you had just a quick WOT, atap may not be scanning fast enough to capture the WOT run.
