PCM Diagnostics & Tuning HP Tuners | Holley | Diablo
Sponsored by:
Sponsored by:

P1133 code

Thread Tools
 
Search this Thread
 
Old 08-03-2006, 08:47 PM
  #1  
10 Second Club
Thread Starter
iTrader: (3)
 
01_ram-air's Avatar
 
Join Date: Jul 2005
Location: Valrico, FL
Posts: 1,245
Likes: 0
Received 1 Like on 1 Post

Default P1133 code

Any suggestions why I might be throwing this code other than bad O2? Just replaced both a couple months ago.
Old 08-03-2006, 10:02 PM
  #2  
TECH Addict
iTrader: (3)
 
Grimes's Avatar
 
Join Date: Mar 2003
Location: Northern NJ
Posts: 2,636
Likes: 0
Received 2 Likes on 2 Posts

Default

if that is an o2 insufficient switching code, then you can delete the code or try the rear o2 sensors from a 2002 vette (bosch 13111 i think?). Long tube headers will cause the code because the oxygen sensors do not heat up as much as with stock manifolds. The bosch ones mentioned have higher wattage heaters to help this problem. If I were you, I would just get the codes deleted, beacause sometimes the bosch's do not solve the problem
Old 08-03-2006, 10:34 PM
  #3  
10 Second Club
Thread Starter
iTrader: (3)
 
01_ram-air's Avatar
 
Join Date: Jul 2005
Location: Valrico, FL
Posts: 1,245
Likes: 0
Received 1 Like on 1 Post

Default

I have no rear o2s since I don't have cats. those have been tuned out already. And I'm running bosch o2s up front.
Old 08-03-2006, 11:35 PM
  #4  
Banned
iTrader: (1)
 
Domestic Demon's Avatar
 
Join Date: Apr 2006
Location: NJ
Posts: 373
Likes: 0
Received 0 Likes on 0 Posts
Default

Originally Posted by 01_ram-air
I have no rear o2s since I don't have cats. those have been tuned out already. And I'm running bosch o2s up front.
I looked up that code and it appears that it pertains to the rear O2 Sensors...very odd, since you have simulators for the downstream sensors

Try getting the code reset. If it comes back again, then you may have to get the rear sensors disabled with a tune.
Old 08-04-2006, 09:23 AM
  #5  
10 Second Club
Thread Starter
iTrader: (3)
 
01_ram-air's Avatar
 
Join Date: Jul 2005
Location: Valrico, FL
Posts: 1,245
Likes: 0
Received 1 Like on 1 Post

Default

Originally Posted by Domestic Demon
I looked up that code and it appears that it pertains to the rear O2 Sensors...very odd, since you have simulators for the downstream sensors

Try getting the code reset. If it comes back again, then you may have to get the rear sensors disabled with a tune.
I had the code cleared yesterday, I'll see if it comes back.

I don't have simulators, they are tuned out already.
Old 08-05-2006, 12:43 PM
  #6  
10 Second Club
Thread Starter
iTrader: (3)
 
01_ram-air's Avatar
 
Join Date: Jul 2005
Location: Valrico, FL
Posts: 1,245
Likes: 0
Received 1 Like on 1 Post

Default

So, is the P1133 for the REAR O2s?

I thought that Bank 1 sensor 1 meant the driver side front O2???

Last edited by 01_ram-air; 08-05-2006 at 01:19 PM.
Old 08-05-2006, 03:56 PM
  #7  
TECH Senior Member
 
2001NBMZ28's Avatar
 
Join Date: Dec 2001
Location: Jacksonville, FL
Posts: 5,399
Likes: 0
Received 3 Likes on 3 Posts

Default

P1133 is bank 1, sensor 1 - drivers side precat.
Old 08-05-2006, 04:30 PM
  #8  
TECH Resident
iTrader: (17)
 
ZL1Killa's Avatar
 
Join Date: Sep 2004
Location: NC - Charlotte area
Posts: 3,747
Likes: 0
Received 0 Likes on 0 Posts

Default

DON'T buy the vette sensors!!! stupid waste of money

what did you change before you got these code(s)?

look up my previous posts and search for the p1133 code and p1153 code... sometimes they run hand in hand.
Old 08-07-2006, 12:17 PM
  #9  
10 Second Club
Thread Starter
iTrader: (3)
 
01_ram-air's Avatar
 
Join Date: Jul 2005
Location: Valrico, FL
Posts: 1,245
Likes: 0
Received 1 Like on 1 Post

Default

Originally Posted by ZL1Killa
DON'T buy the vette sensors!!! stupid waste of money

what did you change before you got these code(s)?

look up my previous posts and search for the p1133 code and p1153 code... sometimes they run hand in hand.

I didn't change anything. Was just driving down the road and threw the code. Car seemed fine.
Old 08-07-2006, 03:15 PM
  #10  
TECH Resident
iTrader: (17)
 
ZL1Killa's Avatar
 
Join Date: Sep 2004
Location: NC - Charlotte area
Posts: 3,747
Likes: 0
Received 0 Likes on 0 Posts

Default

the p1133 is the front 02... not the rear


what have you changed on your car? have you changed injectors and what kind do you have?
Old 08-07-2006, 04:14 PM
  #11  
10 Second Club
Thread Starter
iTrader: (3)
 
01_ram-air's Avatar
 
Join Date: Jul 2005
Location: Valrico, FL
Posts: 1,245
Likes: 0
Received 1 Like on 1 Post

Default

Originally Posted by ZL1Killa
the p1133 is the front 02... not the rear


what have you changed on your car? have you changed injectors and what kind do you have?
The only things that I've done to the car are the mods in the sig.
Well, Tr6 spark plugs, been running those for about 8 months, new ones about 3-4 months ago and MSD wires. Stock injectors.
Old 08-17-2006, 01:26 PM
  #12  
10 Second Club
Thread Starter
iTrader: (3)
 
01_ram-air's Avatar
 
Join Date: Jul 2005
Location: Valrico, FL
Posts: 1,245
Likes: 0
Received 1 Like on 1 Post

Default

update/
installed new 02, problems resolved.
Old 12-07-2006, 11:00 PM
  #13  
TECH Regular
iTrader: (24)
 
minesfaster's Avatar
 
Join Date: Sep 2005
Location: California
Posts: 452
Likes: 0
Received 0 Likes on 0 Posts
Default

I have the same issue but i swapped out the 02 sensor with a used one and it didnt fix my problem. ALl i did was put the stock exhaust back on. couls this be why i am not passing smog ?



Quick Reply: P1133 code



All times are GMT -5. The time now is 11:24 PM.