Shep02SS

When I paste my afr error % to the primary VE table what value should I use +,-,or average. I thought it was the average and then multiply by %, but I did that and after two runs the error% is still way off and the afr is still inconsistant. Any input appreciated. Thanks

Dragman

use average and muliply by % till u get close then use 1/2 %

PurplePiss

Clear the fuel trims and don't start logging until the car is completely warmed up.

Shep02SS

The ltft is disabled so would it matter if reset them?

TAQuickness

iTrader: (28)

would not matter. but it sounds like it'd be worth a shot to double check and make sure you tune is set up correctly for SD mode.

Shep02SS

I am using the maf enhanced os right now and I think it is setup correctly for olsd, but if I changed the os to speed density enhanced would it guarentee that I am in olsd?