Where to set shift points while installin hypertech?
#1
TECH Fanatic
Thread Starter
iTrader: (4)
Join Date: Feb 2008
Location: In my Science Lab .
Posts: 1,056
Received 0 Likes
on
0 Posts
Where to set shift points while installin hypertech?
I just recieved my power programmer I wanna get some ideas on how to use help me out fellas ,NON RFG, AN, SHIFT POINTS FOR TRANSMISSION ?
#2
TECH Resident
iTrader: (17)
Join Date: Sep 2004
Location: NC - Charlotte area
Posts: 3,747
Likes: 0
Received 0 Likes
on
0 Posts
as you want with the hypertech, idk about shift points but I do know if you have a stock cammed/headed t/a then put your rev limiter at 6000rpm; our stock cars make no power above 5800 i think from what I have seen.
also, you are in New Orleans... ever heard of Thunder Racing? you would probably be better off going to them to get a FULL dyno tune and selling that hypertech
also, you are in New Orleans... ever heard of Thunder Racing? you would probably be better off going to them to get a FULL dyno tune and selling that hypertech
#3
TECH Fanatic
Thread Starter
iTrader: (4)
Join Date: Feb 2008
Location: In my Science Lab .
Posts: 1,056
Received 0 Likes
on
0 Posts
I will real soon {get a dyno tune} but I just changed my rear end to 3.42:1 so I needed to correct everything and the shift point was off because I didn't understand it .