full kooks vs slp long tubes and axle back
05-22-2012, 10:33 PM
#1
Teching In
Thread Starter
Join Date: May 2012
Location: wrightsville pa
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
full kooks vs slp long tubes and axle back well basicly i just put slp loudmouths on my car a week ago and now the next step for me is a set of long tubes. now i seen people going with slp and then using the factory mid pipes,and also seen alot of people just running full kooks and corsa. so does anyone now how much hp diffrents would thier be if any?
thanks jon
thanks jon
05-23-2012, 11:59 PM
#2
On The Tree
Join Date: Jan 2011
Location: Orlando, Fl
Posts: 173
Likes: 0
Received 0 Likes
on
0 Posts
Midlength to Longtube headers is about a 10-15rwhp difference. Much more noticeable if you plan on a bigger motor, or forced induction
I am running no cats into factory mid pipe with an x-pipe welded in into a custom magnaflow axle back. No loss of power. I'm sure a full custom mandrel bent 3in exhaust would be best, but my setup worked for now
I am running no cats into factory mid pipe with an x-pipe welded in into a custom magnaflow axle back. No loss of power. I'm sure a full custom mandrel bent 3in exhaust would be best, but my setup worked for now
05-25-2012, 12:21 AM
#3
TECH Fanatic
iTrader: (1)
Join Date: Mar 2005
Location: Fort Wayne, IN
Posts: 1,237
Likes: 0
Received 0 Likes
on
0 Posts
Not sure where your budget is but I am very happy with the ARH LT's and their mid pipe. No cats. Very quiet with factory axlebacks, and perfect (for me anyway) w/ GXP axlebacks.
). No complaints here whatsoever. 
Trending Topics
09-09-2012, 06:00 PM
#9
12 Second Club
Join Date: Jul 2006
Location: Goldsboro, NC
Posts: 372
Likes: 0
Received 0 Likes
on
0 Posts
You can run Kooks LT's and their x-pipe (either catted or not) and still tie into your axle back. That's what I run but I'm a solo axle back. I like it loud!
Tate
Tate
.
09-12-2012, 09:21 AM
#11
On The Tree
iTrader: (1)
Join Date: Jan 2009
Location: Hope Mills, NC
Posts: 120
Likes: 0
Received 0 Likes
on
0 Posts
Look inside at the cat when you get them. The 2 1/4" pipe is almost touching the cat element. The set I installed got cut apart and fixed before I would install them.
09-21-2012, 08:55 PM
#12
Teching In
Thread Starter
Join Date: May 2012
Location: wrightsville pa
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
im almost have tempted to knock the cats out and have them tuned out when i finally do get around to getting a set of lt, then just put a set of mufflers on it.
jon
jon
