Aeromotive Fuel Pressure Regulator, L76 G8 engine parts, LS6 Fuel rails, etc
Thread Starter
10 Second Club
iTrader: (19)
Joined: Sep 2010
Posts: 250
Likes: 0
From: Carbondale, PA
Aeromotive Fuel Pressure Regulator, L76 G8 engine parts, LS6 Fuel rails, etc Category: Engine - Intake/Fuel
Price: $1
Part Fits: 2010+ Camaro, 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette, 04-06 Pontiac GTO, 04+ Cadillac CTS-V, 67-92 Chevrolet Camaro, 67-92 Pontiac Firebird, Front wheel drive vehicles
Location (State): PA
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6, LT1/LT4
LS Engine?: Fits LS Engine
First up is an Aeromotive Fuel Pressure Regulator pn 13101 for use with fuel injection and nice for a boosted setup. The FPR is brand new never been used. I bought for a turbo engine I was building but never finished so I am throwing it up on here. I will include a link to the product on aeromotives site. These go for 145-185$ I am looking to get $125 shipped
http://aeromotiveinc.com/products-pa...***-regulator/ SOLD!!!!
Next up is a fuel rail set up from when I bought my LS6 intake. Since then I have upgraded to a FAST intake and rail setup so the rails are not needed. They are in good condition, just have no use for them. Looking to get $45 shipped. SOLD!!!
Up next are all parts from a 08 Pontiac G8 with around 28k on it. witht he exception of the lifters, they are new GM replacements that were installed by the dealer after one crapped out. These lifters have around 150 miles on them. What you see is what you get and all removed parts were removed due to an aftermarket upgrade. Also if the prices are too high please forgive me and pm me about it because I dont really know what these parts go for. If they are marked to low then you will make out. All parts are OBO also!!
Stock L76 cam, last cam journal has a little rust on it but I would not be scared to install it by any means. The effected area is shown up close in the other pics. $60
Next is the stock valley cover from the same car. Looks brand new but is used. $50
Next is stock timing chain and cam gear from the G8, $30
Next is the stock crank pulley and bolt. $50 SOLD!!!!
Next is stock length pushrods from the g8 SOLD
And lastly here are the super low mile lifters. $80 SOLD!!!!
Last edited by 95LTXZ28; Jul 24, 2013 at 05:58 PM. Reason: Price reduction
Trending Topics
I certainly don't mean any offense, but thought you might want to know that you probably want to pitch that bolt into the trash - those are 'single-use' torque-to-yield pieces. Nothing wrong with re-using the pulley though. 
Good luck with selling all the remaining stuff!
Good luck with selling all the remaining stuff!
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo Thread Starter
10 Second Club
iTrader: (19)
Joined: Sep 2010
Posts: 250
Likes: 0
From: Carbondale, PA
I certainly don't mean any offense, but thought you might want to know that you probably want to pitch that bolt into the trash - those are 'single-use' torque-to-yield pieces. Nothing wrong with re-using the pulley though.
Good luck with selling all the remaining stuff!
Good luck with selling all the remaining stuff!
