Ebony seat belts, wheel spacers
#1
Ebony seat belts, wheel spacers
Category: Accessories
Price: $1
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): TX
Item Condition: Used
LS Engine?: Non-LS Part
- $60 shipped
2 Billet 1.25" wheel spacers w/lugs and hubcentric rings for our F-bodies. 5 x 4.5" (120.65mm)
- $30 shipped
#6
TECH Apprentice
iTrader: (5)
I have a set of Corvette Centennial Wheels with a 57mm offset and a 70.8 bore. I don't understand much about wheels yet and wanted to see if you could help. In terms of offset, where would these spacers put me at? I'm aiming to be at a 40mm offset at the rear. I'm ready to buy these if it'll work for my application. Thanks in advance!
Edit: I have attached the a pic of the specs of the wheels currently on my car. Hope that helps answer my questions a little better.
Edit: I have attached the a pic of the specs of the wheels currently on my car. Hope that helps answer my questions a little better.
Last edited by L3THAL_Z28; 01-19-2015 at 09:52 PM.
#7
The pic helped because I needed to know what the width was. These spacers are 1.25" which is about 32mm. If you put these on your car with those wheels, you'll have a 25mm offset and stick out too much. Those wheels should look perfectly fine the way they are. You need a 17mm spacer to get a 40mm offset. This will do the trick if you really need to though.
http://www.ebay.com/itm/Eibach-Sprin...f8d517&vxp=mtr
http://www.ebay.com/itm/Eibach-Sprin...f8d517&vxp=mtr
Trending Topics
#8
TECH Apprentice
iTrader: (5)
Thanks for the clarification. There's no issue with the wheel fitment or anything but they look like they are tucked in. I want them to sit more or less flush with the fender and I read somewhere on here that I would need a be at a 40mm offset to do so. Either way good luck with the sale and here's a free bump for yah.