FS: 91 FC RX-7 - LS Swap Ready
05-23-2016, 12:49 PM
#1
Teching In
Thread Starter
iTrader: (17)
Join Date: Jul 2007
Location: Texas
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
FS: 91 FC RX-7 - LS Swap Ready Year: 1991
Make: Mazda
Model: RX-7
Price: $4500
Mileage: 0
Private or Dealer Listing: Private Listing
Location (State): TX
Color: Black
This is a swap ready car. Just add your drivetrain, cooling, fuel etc... The car has a full interior, T2 rear diff / axles, many new / upgraded parts and a lot of the little misc tasks are completed. No engine / transmission. Below is a complete list of all that is done to the car. There might be a few more odds and ends but this is the majority of the list.
Car was fitted with the Ronin mounting kit so the transmission tunnel has already had the holes drilled for the mounts. I do have other swap parts as well for the car but those are not included.
If interested you are welcome to message me with any questions. Please, only serious buyers need to comment/message.
All of my most recent pictures are on my home PC so I will add them once I am home.
Price: $4,500
New Axle Nuts
New Brake Pads
New Russell Rear Stainless Brake Lines
New Russell Front Stainless Brake Lines
New Lateral Link Grease & Rubber Boots
New Racing Beat Rear Toe Eliminators
New MMR Delrin Diff Bushings
New Front Diff Mazda Comp Mount
New Lower Spherical Bearing Seals
New Pinion Snubber
New Energy Suspension Control Arm Bushings
New Grannys Sway Bar Spacer Kit
New Racing Beat Front Sway Bar w/ Urethane Bushings
New Mazdatrix Front End Links
New Timken Front Hub Races
New Timken Inner Wheel Bearings
New Timken Outer Wheel Bearings
New Inner Seals
New Moog Front Outer Tie Rod Ends w/ Service Port
New Moog Front Inner Tie Rods
New Moog Front Rack and Pinion Bellows
New Moog Front Ball Joints
New Front Brembo Brake Rotors
New Paint in Engine Bay - Color matched to Factory Color
New Foam in all of the HVAC boxes behind the dash. Boxes were disassembled, old foam removed & new foam applied.
New Heater Core
S4 T2 Diff / Axles
S4 Front Lower Controls Arms w/ Replacable Ball Joints
Clearanced Firewall for Longtubes
Clearanced Trans Tunnel for T56 sensors
Applied Undercoat to Wheel Wells & Trans Tunnel
Heater lines relocated with New heater hose and Gates Hose Clamps
Brake Calipers were cleaned & Painted Red with Duplicolor Caliper Paint
Gas Tank was pulled out and cleaned up
Windshield Wiper plug has already been removed from Factory Harness
All parts removed during this process have been cleaned and painted if necessary. The car also has a T2 hood on it now.
Thanks for looking.
Last edited by BushyTea; 05-23-2016 at 06:36 PM.
