1998 Mustang Roller, set up for LS
03-17-2017, 02:19 PM
#1
1998 Mustang Roller, set up for LS Year: 1998
Make: Ford
Model: Mustang
Price: $1950
Mileage: 205000
Private or Dealer Listing: Private Listing
Location (State): MO
Color: White
You will need a LS motor, transmission (T56, TH400), radiator/fans, wiring harness, exhaust, and to finish the fuel system. This is the lis of parts currently installed on the car:
AJE K-member with LS motor mounts
AJE T56 Crossmember (AJE's website says this will work with TH400 also)
Cold air intake into fender well with Spectre air filter
Foxbody 8 inch Rearend with SN95 axles (not sure of the gear ratio)
Enkei RPM2 Wheels:
Front - 17x8 +35 offset
Rear - 18x9 +38 offset
Tires (decent tread):
Front - (Nitto NT555) 225/40/17
Rear - (Nitto NT555) 255/35/18
The car comes with a brand new 94-97 fuel tank, HFP 255LPH Fuel Pump, single piece head lights, and over the axle exhaust pipes. Also have the complete engine harness and stock driveshaft from the Mustang. The car was originally an auto, however I installed a clutch pedal and hydraulic clutch master cylinder. So you can go Auto or T56.
There are a few areas on the car where the paint is chipping, and the interior is 6.5/10.
Last edited by Sube; 04-24-2017 at 07:10 AM.
