I have a Precision PT88 turbo for sale. The turbo is new, with a poslished compressor.

Specs:
-Inducer mm.- 88mm
-Wheel Inducer- 3.465"
-Wheel Exducer- 4.630"
-Wheel Trim- 59
-Inlet/Outlet Size- 4"/3"
-Bearing System- Pro Race
-A/R Ratio- Tan .96
-Wheel Inducer- 3.730"
-Wheel Exducer- 3.270"
-Wheel Trim- 77
-Max. Rated HP- 1250

Retails for $1650 will sell for $1250 shipped.

Paypal preferred.

Pics:

 

Stupid question but it this a T4 flange? might be interested in it

 

Yes it's a T4 flange...

 

Cool thanks...trying to decide if that A/R ratio is best for me...hmmmmmmmmmmm

 

With the 408 you should have no problem spooling it...What are your thoughts on it?? What kind of setup are you trying to attain???

 

Wasnt really thinking of the spool time...i know i am in the clear with that. Was more concerned about backpressure, been reading a few threads on here about A/R ratio's and back pressure so i was thinking i might need to go with something a little larger then .96...maybe 1.01??

 

This turbo is more than capable of pushing your 408 to well over 800rwhp. It has been done many times by members here on the board.

 

I think that you will do well with it too...You'll be able to use ALL of the turbo and you'll have a bunch of torque even before the turbo kicks in...I think that it's enough turbo for you...It's a street car right??

 

How much picked up?

 

pm sent

 

ttt...

 

suppose that will bolt up to the Livernois truck turbo kit?

 

If it's a T4 flange and this also comes with a 4" dp so you may need a step down if you're going to be running a 3" exhaust....

 

I dont know if it will bolt up to their kit. I build my own set-up's.

ttt...

 

$1250 shipped. You pay paypal fees (3%). I need the money for my rods and pistons.

 

Ill buy it man...1250 shipped

 

sale pending

 

damn it comes witha 4 inch down pipe also?

 

no down pipe. just the turbo.

sale pending. funds are on the way.

 

pm sent