449 CI Semi Solid Roller Corvette
#1
LS1TECH Sponsor
Thread Starter
iTrader: (6)
Join Date: Nov 2001
Location: Reading, PA
Posts: 2,102
Likes: 0
Received 0 Likes
on
0 Posts
449 CI Semi Solid Roller Corvette
Well, I'll be the first to post our cool little project we have going on. It's a 2003 Z06 Corvette.
We're using a re-sleeved LS7 block from Steve @ Race Engineering bored to 4.160". A Lunati 4.125" crank, Callies rods and Diamond pistons. Heads are ET 4.100" LS7. Cam is custom ground. Don't ask what I mean about semi-solid. I'll explain all that when we're finished. Rockers are Jesel's.
We're using Kook 1-7/8" headers, a custom sheet metal intake, 100mm throttle body and a GZ vacume pump kit.
I'll post up all of the driveline modifications a little later but it will include a carbon fiber drive shaft and a RAM twin disk clutch.
This is a pump gas engine. Should be interesting.
We're using a re-sleeved LS7 block from Steve @ Race Engineering bored to 4.160". A Lunati 4.125" crank, Callies rods and Diamond pistons. Heads are ET 4.100" LS7. Cam is custom ground. Don't ask what I mean about semi-solid. I'll explain all that when we're finished. Rockers are Jesel's.
We're using Kook 1-7/8" headers, a custom sheet metal intake, 100mm throttle body and a GZ vacume pump kit.
I'll post up all of the driveline modifications a little later but it will include a carbon fiber drive shaft and a RAM twin disk clutch.
This is a pump gas engine. Should be interesting.