Choppers

iTrader: (60)

How would this amp work with 2 of these 8' subs that I will provide the link for. Would it be to much not enough? Also anyone ever use power acoustik? I have have never used them before. Ya'lls thought will be helpful.

Amp:
http://www.crutchfield.com/S-g9nwwaS...k-TS960-4.html

Subs I will have 2 of these:
http://cgi.ebay.com/RE-AUDIO-US-AMPS...3A1%7C294%3A50

Engine_HP

iTrader: (1)

no they will not work together,

Choppers

iTrader: (60)

to much power?

Engine_HP

iTrader: (1)

no,


this is a 4 channel amp when bridging it to 2 channel it will stable at 4 ohm,
the subs are dvc 4 ohm, when connecting them in parrallel the will produce 2 ohms load,

Choppers

iTrader: (60)

ok yea i think i am just going to save up for what i really want anyways.

Snootch

iTrader: (3)

You could use that amp with those speakers, but to power more than a pair of subs. You could wire each of those subwoofers voice coils in series so they are essentially 8 ohm subs, then wire both the subs in parallel so they present a 4 ohm load to the amp on channels 3-4 (bridged). Then use channels 1 & 2 to power your front speakers (front doors). Remember, If you will be using the factory deck you will need a line output converter as well as some RCA cables to connect to the signal input to the amp. Also, don't forget to buy a decent 8 gauge power wiring kit for the amp as well. You might want to check out Kee audio (sponsor) to see what they can do for you as well. --->