Window issue
#1
On The Tree
Thread Starter
Join Date: Sep 2010
Location: Virginia Beach, VA
Posts: 114
Likes: 0
Received 0 Likes
on
0 Posts
Window issue
So I am just wondering if I should just do the motor, or if it's just a regulator, or what the heck is going on in my window, because I haven't done any window or door panel stuff in a few years (since my old grand am = no fun).
Basically, my passenger window will roll down just fine, but when I go to roll it up, it goes only about 75% and stops. Now if I leave the car running (turned off, it takes FOREVER) I can wait about 30 seconds and it will work again but only go up another 5-10%, then wait another 30 sec, and it will finally go up all the way.
Anyone had this issue?
Basically, my passenger window will roll down just fine, but when I go to roll it up, it goes only about 75% and stops. Now if I leave the car running (turned off, it takes FOREVER) I can wait about 30 seconds and it will work again but only go up another 5-10%, then wait another 30 sec, and it will finally go up all the way.
Anyone had this issue?
#7
TECH Senior Member
iTrader: (4)
Join Date: Dec 2003
Location: Arlington TX
Posts: 5,276
Likes: 0
Received 0 Likes
on
0 Posts
I replaced my driverside motor week before last and I dont think it ever went up or down so fast. Makes my passengerside seem like it's hardly moving and it was the fast one