Fuel gauge question
09-16-2013, 03:57 PM
#1
Staging Lane
Thread Starter
iTrader: (1)
Join Date: May 2007
Location: Macedonia, Europe
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
Fuel gauge question I just converted my 01 Camaro from an A4 to an M5. The car runs great and everything, put in a new PCM, all I need done is the crankshaft position sensor learn procedure done.
Since I did the conversion, I noticed my fuel gauge going from empty to full in every freaking turn. Why is this happening? It was not happening before. Anyone have any idea?
Since I did the conversion, I noticed my fuel gauge going from empty to full in every freaking turn. Why is this happening? It was not happening before. Anyone have any idea?
09-29-2013, 05:52 PM
#2
TECH Fanatic
iTrader: (7)
Join Date: Jun 2004
Location: Ventura County, California
Posts: 1,476
Likes: 0
Received 0 Likes
on
0 Posts
Did you remove the fuel pump at any point? I installed a new fuel pump didn't prime it and after 2 weeks it wouldn't read the amount of gas i had in the gas tank. Than i ran out of gas a few weeks ago, fill up and all of a sudden my fuel gauge is reading properly. Don't know if thats your problem.
09-29-2013, 05:59 PM
#3
Staging Lane
Thread Starter
iTrader: (1)
Join Date: May 2007
Location: Macedonia, Europe
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
Hey friend,
I stated what I did to car, I did not replace the fuel pump. I don't know if it's this new PCM and the programming...is that possible?
I stated what I did to car, I did not replace the fuel pump. I don't know if it's this new PCM and the programming...is that possible?