factory keyless entry wiring?
#1
TECH Resident
Thread Starter
Join Date: Nov 2001
Location: Chicago, IL
Posts: 894
Likes: 0
Received 0 Likes
on
0 Posts
factory keyless entry wiring?
A couple weeks ago I installed an electric oil pressure gage and immediately after, the keyless entry mysteriously stopped working. Replaced the batteries in both fobs but neither works.
I wired the gage as such: Ran hotwire for light to the interior dimmer fuse; ran 12V power for gage to instrument panel power fuse; grounded light to a metal piece under the steering column inside the dash; grounded gage to that point on the driver's side of the engine compartment between the fuse block and emissions sticker. There was already something grounded there but I don't know what.
Where's the sensor for the remote? I think it's pretty likely I knocked a wire loose when I was pulling stuff through.
I wired the gage as such: Ran hotwire for light to the interior dimmer fuse; ran 12V power for gage to instrument panel power fuse; grounded light to a metal piece under the steering column inside the dash; grounded gage to that point on the driver's side of the engine compartment between the fuse block and emissions sticker. There was already something grounded there but I don't know what.
Where's the sensor for the remote? I think it's pretty likely I knocked a wire loose when I was pulling stuff through.