DVS99TRANS

iTrader: (7)

Has anyone ever seen or heard of anyone carrying it??? I know the vette runs off the same basic PCM and don't see why it couldn't be done. The only thing I don't know is if the HUD runs off the PCM or the console itself???Easiest case scenerio jumping/splicing a couple wires and fabricating if into the front dash. It is a kind of pointless mod and doesn't make you perform any better but would be very unique I think and wouldn't mind doing it. Any one know???

pentavolvo

In the vette it runs off the gauge cluster

Jon5212

iTrader: (2)

+1 I think that would be pretty cool too, not sure of the cost to do that though.

DVS99TRANS

iTrader: (7)

So atleast you wouldn't have to mess with the PCM it sounds since it goes of the gauge cluster. I'm half thinking about buying the HUD and giving it a try. Just need to find a wire diagram for a vette to see exactly what wires it will tap in to. I'm just not that crazy about ripping/cutting a hole in the dash I work on aircraft avionics splicing and soldering stuff all the time. I can't see it being anywhere worse than that.

Shockwave179

iTrader: (7)

If you can't get the corvette setup to work, Defi makes HUD units..

VIP1

Here is an older thread on HUDs:
https://ls1tech.com/forums/appearance-detailing/689186-c6-hud-fbody.html

DVS99TRANS

iTrader: (7)

That may be, but I'm also trying to find what wires that the HUD runs off. I have EVERY RESOURCE on wiring at my disposal. I work in an avionics shop for HC-130s, me installing it isn't the question. It's finding what inputs the HUD needs??? It will of course need power and ground, but what other inputs that an f-body might not have that a vette will. I mean I could always pay an arm and a leg and buy it from GM directly and jump it from the console. Kind of a very technical question. Not trying to be rude, just looking for a little more than what I've found.