Marc3.4V6

iTrader: (1)

My lower control arm bushings need replaced and one of my inner tie rods is bent, can I do this in my driveway? Or is it really hard without a lift? Also, I wanted to try to get 1LE bushings, but if I did that, would I have to replace the uppers too ? My balljoints are squeaking a lot on turns too.

1le are pretty hard to find, what other brands should I look for?

sroach20

iTrader: (31)

moog!

redemn93

iTrader: (4)

yes on the moog. it isnt hard at all in your driveway, provided that you properly support the car with jackstands.

Marc3.4V6

iTrader: (1)

thanks guys.

beaSSt

Any idea on the Moog part numbers for the front upper and lower control arm bushings?

Do they make a replace for both the standard and the 1LE bushings?

sroach20

iTrader: (31)

K6689 and K6490 are the numbers, same for regular and 1le.

sroach20

iTrader: (31)

for the inner tie rod make sure you rent the tool from oreilly or vautozone. i used a ball joint press to change my control arm bushings, it was $30 from harbor freight.