What should I sell my ls1 for
#4
Devil Dog, OohRah!
iTrader: (1)
Join Date: Mar 2006
Location: Des Moines, Iowa
Posts: 421
Likes: 0
Received 0 Likes
on
0 Posts
Appreciate it. To answer your question, if you sold it complete with ECM, $2500 easy. Without ECM, maybe $2000? Regardless, I wouldn't take less than $1500 for the complete motor. Should sell pretty quickly.
#5
TECH Enthusiast
iTrader: (15)
Join Date: Nov 2006
Location: Spring,Tx
Posts: 525
Likes: 0
Received 0 Likes
on
0 Posts
just to give you an idea, they're listed all over the place ranging anywhere from $800-$2500...a lot of them in the 40-50k mile range are usually around the 1200 mark... hope that helps.. just giving you input from what I have seen when I was looking at used motors for my car..
edit: meant to say that the ones going for 2-2500 usually have transmissions and ECU's with them as a pull outs
edit: meant to say that the ones going for 2-2500 usually have transmissions and ECU's with them as a pull outs
Last edited by GreatWhiteZ28; 03-16-2012 at 08:44 PM.
Trending Topics
#8
w/o an intake or with an LS1 intake, it is about $800-$1000.
LS1's just aren't worth much as they are all older, and it is hard to tell the pampered ones from the ones most people on here own.
I see you are in Victoria. This weekend it might be worth more than usual.
LS1's just aren't worth much as they are all older, and it is hard to tell the pampered ones from the ones most people on here own.
I see you are in Victoria. This weekend it might be worth more than usual.
#12
If you can verify condition, it would be worth about 1200.... but, after you pull it and its on the ground the price generally goes down... Id never pay a premium price for a motor I couldnt see run... if possible, leave it in the car.. if its got good pressure and such, you will get a premium price.. ask 1800, take 1200 and run.. haha
#15
Teching In
Join Date: Jun 2012
Location: Springfield, MO
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
i just payed $800 for an LS1 w/electrical. when i went to pick it up, it was completely taken apart. Arn't u suppoesed to keep track of connecting rod placemen/orientation and stamp 'em when removing?