need help finding a tool to hold the crank in place..

[1sicws6]

The Ls shop I use to work at had a tool that bolted up in place of the started on a ls motor which worked great for torqueing down pulleys but I cant find it does anyone have a clue who sold it? thanks

[BADD SS]

Originally Posted by 1sicws6

The Ls shop I use to work at had a tool that bolted up in place of the started on a ls motor which worked great for torqueing down pulleys but I cant find it does anyone have a clue who sold it? thanks

Kent-moore flywheel lock tool. Dont know the part # though.

[camarof41_383]

http://www.etoolcart.com/flywheelhol...j-42386-a.aspx

I want one of these but keep hoping someone will make a tool to do the same thing for cheaper.

[Pocket]

Simple

Take an old flexplate and cut a small section off it, then weld it to a piece of scrap steel and drill two holes in it

[Mike52]

Originally Posted by Pocket

Simple

Take an old flexplate and cut a small section off it, then weld it to a piece of scrap steel and drill two holes in it

Pocket, I like the way you think!!

[LS1MCSS]

Just make two small brackets to bolt this on where the starter goes.

http://cgi.ebay.com/ebaymotors/UNIVE...item20b60555a4

[Pocket]

$50-100 vs free using old scrap

Answer is simple in my book

[Gray86hatch]

screw a bolt in the block bellhousing hole or use the bellhousing

Tim

[01ssreda4]

Kent Moore tool is better..........