1999 hugger orange ss (need to move) lots of extras
12-08-2011, 11:37 AM
#1
10 Second Club
Thread Starter
iTrader: (35)
Join Date: Aug 2005
Location: paducah, ky
Posts: 573
Likes: 0
Received 0 Likes
on
0 Posts
1999 hugger orange ss (need to move) lots of extras Year: 1999
Make: Chevrolet
Model: Camaro
Price: $11500
Mileage: 98000
Private or Dealer Listing: Private Listing
Location (State): KY
Color: Orange
Transmission: Manual
Drivetrain: Rear Wheel Drive
1999 SS CAMARO HUGGER ORANGE
98k Miles
6SPD
Convertible
Factory options:
SS Floor mats
SS grille
6 Disc Changer
Leather (EBONY/GREY)
Power seats, windows....
NEW (things I actually did to the car since I traded for it)
QUICK PERFORMANCE 9" Narrowed 6"
-drain and fill plugs
-Moser 35 spline axles with Motive 4.56 gears and Chrome Moly drag spool
-Aluminum Daytona Pinion Support
-Yukon Nodular center section
-5/8 Race Screw in drag studs
-1350 Billet Yoke
" (I do have recipt) $2,065 -purchase date 10/9/2011
Brute Speed PST 3.5" Aluminum Drive Shaft with 1350 Joints and upgraded forged slip yoke (I do have recipt) $450.00 -purchase date 10/5/2011
Texas Drivetrain Stage 3 Clutch (recipt on hand) -purchased 9/21/2011
New Tick Performance adj Master Cylinder (Have recipt) 10/24/11 $338.79
Billet Specialty Street Light wheels fronts and back (have recipt) $944.00 -purchased 10/4/2011
Hoosier 275/60 Drag radials with Kumho Radial 165/80's in front
TNT Powering Kit (I put it on the car when I was doing all the rear end work)
-has nx purge
-Nitro Daves ashtray swith panel
MSD 8733 2 Step
Here is a list of stuff I had in folder when I traded for the car, so I do not many details on it!
Mild cam
ported ls6 oil pump
ported stock casting 853 heads with 2.02/1.60 valves
LS6 Intake
S2 Throttle body
SLP Bellow
Carbon Fiber LID
Coated Longtube Headers into SLP Loudmouth Exhaust
BMR Subframe Conectors, Relocation brackets, lower control arms, adj panhard bar, Adj Torque arm, Driveshaft safety loop....
Windows Tinted
Gauge pod with shift light in pod and vacume gauge and Air Fuel Ratio Gauge
Light Bar *LOOKS VERY GOOD WITH TOP DOWN
Im forgetting some things but as I remeber I will post!
WILL ENTERTAIN TRADES, BUT TRADE VALUE IS HIGHER!!!
THANKS FOR LOOKING CHRIS! (270)9943702!~
ALSO CAR HAS BEEN TUNED, RUNS AS GOOD AS IT LOOKS! NO CHECK ENGINE LIGHTS OR DASH LIGHTS ON IN CAR. Except for the ABS light considering the rear end swap!
Do not have Dyno #'s but do have track times were I had took it to track with old stock Junk master cylinder and could not shift it as needed!!!!
First time at track got no time on account of snapping 10bolt
Second and last time at track ran at 7.2x with a 1.4x 60ft and 93.xx mph on the bad master cylinder! I feel the car is easily good for 6.9x's!
YOU CAN CALL OR TEXT ALSO 270-994-3702
http://www.youtube.com/watch?v=a0Z2GGoQGTw
[IMG]http://i163.photobucket.com/albums/t300/onebad97vette/int.jpg
[/IMG]
