Year: 1994 Make: Chevrolet Model: Caprice Price: $9950 Mileage: 700 Private or Dealer Listing: Private Listing Location (State): NJ Color: Blue Transmission: Automatic Drivetrain: Rear Wheel Drive LS Engine?: Car has LS engine
I am selling this on behalf of a friend. He is beyond busy so I will be handling everything up until the point of seeing the car, checking it out and sending it to a new home. The vehicle is located in Scotch Plains, NJ. The car is a prized possession to him however he doesn't have much time to enjoy it and would like to see it in a good home.
I was fortunate enough to take a ride in the car and this thing boogies. If you want a basically bulletproof car to drive to the track, run 10s and head home, this is it. The owner has a ton of extra parts (blower belt, interior pieces, etc) that will go with the car. There a lot of little details that make the car different in a good way (such as the John Moss signature under the trunk lid). There is also a large spoiler for the car as well not shown.
The car was assembled professionally (Combination Motorsports) and as many know, to recreate or assimilate the car today would certainly cost way more than the asking price. The engine has 700 miles on it since the rebuild by Ellwein Engines. It was tuned by Bryan Herter, mainly dialing in the tune on the track. The car has gone 10's multiple times however this was a little while ago and the owner is looking everywhere for the slips. Based on the power and setup, it can back up the claim.
The car has been garage kept except for the past couple weeks when it has sat outside the house. Of course the pollen and such has gotten to it.
1994 Chevrolet Caprice - (Imp SS Clone)- $9,950 OBO
- 383 LT1 Built by Ellwein Engines - Callies DS crank, Oliver 5.7 Rods, SRP Blower Pistons, Total Seal Gapless Rings, etc etc. (Full documented rebuild available upon request)
- Iron heads ported/polished/larger valves/springs etc by Combination Motorsports
- Ported LT1 Intake
- Procharger D1SC Blower Pullied for ~15lbs / Combination Motorsports Bracket/Tensioner
- Level 4 FLP 4L60E
- Combination Motorsports FMIC
- 3.73 Pro Auburn built rear
- Fuel Cell w/ A1000
- Weld-in Roll Bar
- Trans/Oil/Steering Cooler
- Tons of suspension upgrades
- no heat/no a/c
There are tons more upgrades but being that many of the mods have been done a while ago, the owner is still tracking down all the documents for the complete list of items. As you can see, the body isn't bad but could use a good polish. A few areas will need some minor body work. It needs a good detail and some wheel polish. The car is loud and mean!