Notices
Vehicle Classifieds This an archive of the older vehicle classifieds, please create a new listing in our Marketplace.
Cars Search
Keyword:

Year:
(Range)

Make:

Model:

Price:

Mileage:

Private or Dealer Listing:

Location (State):

Color:

Transmission:

Drivetrain:

LS Engine?:


Parts Search
Keyword:

Category:

Price:

Part Fits:










Location (State):

Item Condition:

Engine:






LS Engine?:


02 SS M6 Modded

Thread Tools
 
Search this Thread
 
Old 06-20-2013, 11:41 AM
  #1  
11 Second Club
Thread Starter
iTrader: (14)
 
NSSANE02's Avatar
 
Join Date: Mar 2008
Location: Houston
Posts: 1,434
Likes: 0
Received 0 Likes on 0 Posts

Default 02 SS M6 Modded

Year: 2002
Make: Chevrolet
Model: Camaro
Price: $16000
Mileage: 93000
Private or Dealer Listing: Private Listing
Location (State): TX
Color: Black
Transmission: Manual
Drivetrain: Rear Wheel Drive

I'm still working on a complete mod list but you can see most of it in my build thread here. I have over $20k in mods, not including the price of the car. The suspension and rear are already set up for big power so it would be fairly easy/cheap to turn it into a reliable 9 second car. Has about 93k miles. Paint has some scratches as you would expect from a 10 year old car but it's not too bad, has been garage kept for the last 6 years. Rear bumper has some paint damage from the rubber over the years. I'm just gauging interest right now but I would sell it as is for no less than $16k, might look into parting it out as well. I could get well over 16k if I parted it.

Here's a short list of the bigger mods:

Full chromemoly tubular suspension front and rear, brand new AFCO DA's up front, Strange race brakes front and rear, 6 pt chromemoly roll bar painted gunmetal, MWC fab 9" rear w/35 spline axles locking diff and 4.11's, Sunoco pin-on hood w/dz rails, fast 90/90, QTP LT's, bullet mufflers (have TSP TD's but in rough shape), Mezier elec water pump, complete fuel system w 6an SS lines for feed and return, black anodized rails, aeromotive fpr, racetronix pump w/hotwire kit, monster clutch, tick master, remote bleeder, pro 5.0 shifter w/ stiffer spring on the 1-2 side, much more that I can't think of right now.










Last edited by NSSANE02; 06-25-2013 at 08:57 AM.
Old 06-22-2013, 09:21 PM
  #2  
11 Second Club
Thread Starter
iTrader: (14)
 
NSSANE02's Avatar
 
Join Date: Mar 2008
Location: Houston
Posts: 1,434
Likes: 0
Received 0 Likes on 0 Posts

Default

Also willing to trade + cash for stockish m6 fbody
Old 06-22-2013, 10:07 PM
  #3  
12 Second Club
iTrader: (6)
 
1fastTransAm's Avatar
 
Join Date: Jul 2005
Location: Chitown-Jax NC-Jax FL-Honolulu-OKC, OK-NOW New Orleans Area
Posts: 626
Likes: 0
Received 0 Likes on 0 Posts

Default

email me some pix to nsmmc2010@gmail.com please. My cousin is looking a SS or WS6
Old 06-22-2013, 11:17 PM
  #4  
11 Second Club
Thread Starter
iTrader: (14)
 
NSSANE02's Avatar
 
Join Date: Mar 2008
Location: Houston
Posts: 1,434
Likes: 0
Received 0 Likes on 0 Posts

Default

Pics sent. There are a lot more in the link in my first post
Old 06-23-2013, 03:13 PM
  #5  
11 Second Club
Thread Starter
iTrader: (14)
 
NSSANE02's Avatar
 
Join Date: Mar 2008
Location: Houston
Posts: 1,434
Likes: 0
Received 0 Likes on 0 Posts

Default

Mods

Engine:
-QTP headers
-Dynomax bullet mufflers, currently just running bullets srtaight off the collectors
-FAST 90mm intake manifold
-FAST 90mm TB
-Custom 4" cold air intake
-ASP pulley
-Meziere electric water pump (street)
-AFX wideband (hidden display, for tuning only)
-Autometer wideband (for display, used on opposite bank of AFX while tuning to ensure accuracy)
-Lingenfelter 2-step
-Speed density tune

Fuel:
-Racetronix pump
-Hot wire kit
-6an braided stainless lines for supply and return
-Aeromotive regulator
-Black anodized aluminum rails
-Trickflow filter
-Spare Racetronix pump

Drivetrain:
-Pro 5.0 shifter
-Tick Performance adjustable master cylinder
-Tick remote speed bleeder
-Monster lvl. 3 clutch & flywheel
-PST alum. driveshaft
-Midwest Chassis fabricated 9"
-4.11 gear
-Strange aluminum center section
-Detroit locker
-35 spline Moser axles
-Backbrace

Suspension/Chassis:
-MWC tunnel mount torque arm
-MWC LCA's & relo. mounts
-MWC PHB
-MWC drag bar
-MWC crossmember with DSS loop
-Racecraft chromemoly K-member
-Spohn solid motor mounts
-Racecraft chromemoly upper & lower control arms
-Strange race brakes front & rear
-QA1r shocks w/300lb springs up front
-AFCO DA shocks w/275lb springs up front (brand new, yet to be installed)
-Stock rear springs and shocks
-Wolfe 6 point chromemoly roll bar
-UMI SFC's

Exterior:
-Shaved front bumper
-Black halos
-Black front turn signals & rear markers
-Graphite GS stripes
-Sunoco pin-on hood
-15X10 Prostars in rear w/ 325 Hoosier DR's (~50%)
-MT 10X28 Slicks for track (less than 5 passes on them)
-Greg Weld 15X3.5 front

Interior:
-New carpet (speed inc.)
-Complete stock sterio system w/ Infinity Kappa fronts
-Silver faced gauges and TA bezel
-Kirkey race seat
-5pt. harness for driver
-Black leather transam passenger seat
-No rear seats
-Wolfe 6 point roll bar (chromemoly)

Following parts are nib yet to be installed
-3 gauge pillar pod
-Autometer Cobalt wideband gauge
-Autometer Cobalt fuel pressure gauge
-Autometer Cobalt shift light thing (don't remember name of it)
Old 06-25-2013, 08:57 AM
  #6  
11 Second Club
Thread Starter
iTrader: (14)
 
NSSANE02's Avatar
 
Join Date: Mar 2008
Location: Houston
Posts: 1,434
Likes: 0
Received 0 Likes on 0 Posts

Default

Pics added to first post.
Old 06-26-2013, 04:49 PM
  #7  
11 Second Club
Thread Starter
iTrader: (14)
 
NSSANE02's Avatar
 
Join Date: Mar 2008
Location: Houston
Posts: 1,434
Likes: 0
Received 0 Likes on 0 Posts

Default

ttt...

Last edited by NSSANE02; 06-27-2013 at 01:03 PM.
Old 06-27-2013, 01:03 PM
  #8  
11 Second Club
Thread Starter
iTrader: (14)
 
NSSANE02's Avatar
 
Join Date: Mar 2008
Location: Houston
Posts: 1,434
Likes: 0
Received 0 Likes on 0 Posts

Default

ttt...
Old 07-01-2013, 01:41 PM
  #9  
11 Second Club
Thread Starter
iTrader: (14)
 
NSSANE02's Avatar
 
Join Date: Mar 2008
Location: Houston
Posts: 1,434
Likes: 0
Received 0 Likes on 0 Posts

Default

Also willing to trade for a C5 or wrecked/blown motor C6
Old 07-02-2013, 07:30 AM
  #10  
11 Second Club
Thread Starter
iTrader: (14)
 
NSSANE02's Avatar
 
Join Date: Mar 2008
Location: Houston
Posts: 1,434
Likes: 0
Received 0 Likes on 0 Posts

Default

Ttt...



Quick Reply: 02 SS M6 Modded



All times are GMT -5. The time now is 07:44 AM.