Originally Posted by lt4malibu

up front: im posting this for a friend who runs a dealership and took this in on trade. knowing im in the LS/aftermartket world and hes not he asked if I knew where he could put this up for sale where someone who would actually know and appreciate what it is would see it. if you have any questions or would like to see the car message me and I will have him call you directly.

2008 ECS C6 Z06 900HP Package
Engine:
-LRB Built RHS 427ci Longblock Rated for 1,200HP
-PRC 285cc LS7 Heads
-ECS Custom “Big Blower” Camshaft
-ECS Stage 1 E-85 Fuel System
-Bosch LS7 1000cc Injectors
-Dewitts Radiator
-D3 Performance High Flow Electric Fans
-Meziere LS7 Electric Waterpump
-Stock LS7 Intake Manifold
-Alky Control Methanol Injection System
Power Adders:
-East Coast Supercharging Novi 2200HD Supercharger System
-Direct Drive Upgrade
-Innovators West 10% Overdrive Balancer
-Alky Control Methanol Injection System
-Complete Autometer Carbon Fiber Gauge Package
-American Racing 1-7/8 Long Tube Headers and Catted Mid Section
-B&B Corvette Cat Back Exhaust
Drivetrain:
-RPM Transmissions Level 7 TR6060
-Mantic 9000 Twin Cerametallic Clutch
-MGW shifter
-Drive Shaft Shop Carbon Fiber Driveshaft
-ECS Built Rear with stock gears, upgraded Drive Shaft Shop Inner Hardened 500M output shafts
Suspension:
Ridetech Level 2 Coil Over System
Summary:
The car is as fully built as a streetable Corvette. the car was built and serviced from 2012 to 2017 by East Coast Supercharging. The car makes 850whp @ 15 psi.

*some other notes - I looked at the car this past weekend and noticed a few things that were not originally in the ad, just want to make sure everything is as clear as it can be but I urge anyone interested to please check the car out in person*

-the factory seat belts are not functional due to the aftermarket front seats the pretentioners/belts no longer bolt to the tracks. there are a few different ways to fix this, simplest would be to put a set of stock seats back in. it does have a 5point harness on the drivers side and you could install one on the passengers side.

-there's a 6 point roll bar in the car, its set up to have swing out door bars but they're not in place - you would need to have a set made (any competent chassis shop could handle this and I can recommend someone if you would like)

-4 studs are sticking through the carpet in the cargo area, looks like they at one point held a nitrous bottle bracket

*price has been reduced to reflect these things. any other questions feel free to PM me

Originally Posted by Jason Hostetter

Does it have an e85 sensor so that it'll also run on pump gas, or is it strictly e85 only? What's your friends bottom dollar, very interested. Thanks