WTB Hi 9 Lo 10 Street Legal 93-02 Camaro
#2
11 Second Club
iTrader: (60)
My car is still up for grabs, here is the thread for it. Plus i just put an OEM SS spoiler on it. Give me your email and I can send you some pics.
https://ls1tech.com/forums/showthrea...=501794&page=2
Tony
https://ls1tech.com/forums/showthrea...=501794&page=2
Tony
#3
TECH Resident
iTrader: (23)
Join Date: Aug 2005
Location: DFW, Texas
Posts: 750
Likes: 0
Received 0 Likes
on
0 Posts
What are you looking to spend? I have a 98 with fully built motor, TNT kit, all bolt ons,90/90,Kooks stepped headers,a lot of suspension, 12 bolt, th350 built with brake, made 648 on very conservative tune. Ran a 6.22 in the 1/8th the only pass i have made in it and I shifted way to early out of 1st. Looks great, has Bogarts, Ultra Z hood, full fuel system, very reliable, passed inspection with all that last year but with a 4L60E, now it has a SES light because of tranny codes. Drives good and is a blast, but I dont have much time for it. Everything has only about 2000 miles on it
http://videos.streetfire.net/video/7...10666f2e3d.htm
18K and I am in Dallas,Texas
PM if interested
http://videos.streetfire.net/video/7...10666f2e3d.htm
18K and I am in Dallas,Texas
PM if interested
#6
I might sell my 97 z28 396 A4. I'd take 17K, motor has about 5k on it trans about 2.5 K. Went 11.68 N/A and 10.86 on a 75 shot. Car was built to run a 250 shot. Has a fjo N20 controller. I'd work out a deal to get the car up to you. For full detail send a PM.
#7
hashtagBMW
iTrader: (38)
Originally Posted by 97blkz
I might sell my 97 z28 396 A4. I'd take 17K, motor has about 5k on it trans about 2.5 K. Went 11.68 N/A and 10.86 on a 75 shot. Car was built to run a 250 shot. Has a fjo N20 controller. I'd work out a deal to get the car up to you. For full detail send a PM.
Why you sell, why you sell?
Tony.
Trending Topics
#11
TECH Fanatic
iTrader: (2)
Join Date: Nov 2001
Location: Baton Rouge
Posts: 1,894
Likes: 0
Received 0 Likes
on
0 Posts
Are you still looking?
Here ya go. The motor is built for heavy nitrous so it's just a kit away from 9s. I'll have some good pics in a few days if you are interested. $20K.
Engine
Katech Resleeved LS1 Block (4.060 Bore) (can go to 4.100)
Katech Billet Main Caps
ARP Main Studs
ARP Head Studs
New Stock Crank
Oliver Billet CM Rods
Diamond Custom Nitrous Pistons
Diamond Piston Rings
GTP Stage III LS6 Custom Ported Heads (flowed over 337cfms)
Custom Ferrea SS 2.100 / 1.60 Valves
T&D Shaft Mount Rocker Arms
Comp Cams Valve Springs
Manley Ultra Light Titanium Retainers
Manley Titanium Valve Locks
Comp Cams CM 1 piece Pushrods
Thunder Racing Custom Solid Roller Camshaft
Cloys Hex-Adjust Timing Set
C5R Timing Chain Dampener
Ported and Blueprinted LS6 Oil Pump
LS6 Intake
TR Ported TB
Katech Cast Al. Valve Covers
Katech Coil Relocation Kit w/ Plug Wires
Motor Completely Balanced and Blueprinted
Drivetrain
Spec Stage IV-F Clutch
Spec Al. Flywheel
McLeod Adj. Clutch Master Cylinder
Stock GM T-56 Transmission
Hurst Chrome Stick Shifter
Moser 9” Rearend
- Detroit Locker
- 35 Spline Gundrilled Axles
- Al. Center Section
- 4 ch. ABS brakes w/ Traction Control
- 4.30 gears
- Narrowed 2.5”
Centerline Convo Pro Wheels
- 15” x 3.5” Front w/ 195/R15 tires
- 15” x 8.5” Rear w/ MT 275/50/15 ET Street Radials
Suspension
Front
- BMR Tubular K-member
- BMR Upper & Lower Tubular A-arms
- BMR Strut Tower Brace
Rear
- BMR 1” Lowering Springs
- BMR Adj. Xtreme Duty Control Arms
- BMR Adj. Panhard Rod
- BMR Adj. Tubular Torque Arm
- QA1 12-Way Adj. Shocks
Exhaust
TR 1 7/8” Long Tube Headers Ceramic Coated
Mufflex 3” Y-pipe w/ 4” Collector
Magnaflow Catback Exhaust System
Brakes
Powerslot Slotted Rotors (Front & Rear)
Hawk HPS Brake Pads (Front & Rear)
General
Factory Hugger Orange Paint
Tan Leather Interior
T-Tops
SLP Ultra-Z Ram Air Hood
- Custom Painted Hugger Orange w/ “Ram Air” & Black Stripes
SLP Bow Tie Grill
Rear Light Panel Custom Painted Black
Factory A/C & Power Steering
46,000 miles
6-point Bolt-in CM Roll Bar w/ Dual Swing-out (not installed)
Here ya go. The motor is built for heavy nitrous so it's just a kit away from 9s. I'll have some good pics in a few days if you are interested. $20K.
Engine
Katech Resleeved LS1 Block (4.060 Bore) (can go to 4.100)
Katech Billet Main Caps
ARP Main Studs
ARP Head Studs
New Stock Crank
Oliver Billet CM Rods
Diamond Custom Nitrous Pistons
Diamond Piston Rings
GTP Stage III LS6 Custom Ported Heads (flowed over 337cfms)
Custom Ferrea SS 2.100 / 1.60 Valves
T&D Shaft Mount Rocker Arms
Comp Cams Valve Springs
Manley Ultra Light Titanium Retainers
Manley Titanium Valve Locks
Comp Cams CM 1 piece Pushrods
Thunder Racing Custom Solid Roller Camshaft
Cloys Hex-Adjust Timing Set
C5R Timing Chain Dampener
Ported and Blueprinted LS6 Oil Pump
LS6 Intake
TR Ported TB
Katech Cast Al. Valve Covers
Katech Coil Relocation Kit w/ Plug Wires
Motor Completely Balanced and Blueprinted
Drivetrain
Spec Stage IV-F Clutch
Spec Al. Flywheel
McLeod Adj. Clutch Master Cylinder
Stock GM T-56 Transmission
Hurst Chrome Stick Shifter
Moser 9” Rearend
- Detroit Locker
- 35 Spline Gundrilled Axles
- Al. Center Section
- 4 ch. ABS brakes w/ Traction Control
- 4.30 gears
- Narrowed 2.5”
Centerline Convo Pro Wheels
- 15” x 3.5” Front w/ 195/R15 tires
- 15” x 8.5” Rear w/ MT 275/50/15 ET Street Radials
Suspension
Front
- BMR Tubular K-member
- BMR Upper & Lower Tubular A-arms
- BMR Strut Tower Brace
Rear
- BMR 1” Lowering Springs
- BMR Adj. Xtreme Duty Control Arms
- BMR Adj. Panhard Rod
- BMR Adj. Tubular Torque Arm
- QA1 12-Way Adj. Shocks
Exhaust
TR 1 7/8” Long Tube Headers Ceramic Coated
Mufflex 3” Y-pipe w/ 4” Collector
Magnaflow Catback Exhaust System
Brakes
Powerslot Slotted Rotors (Front & Rear)
Hawk HPS Brake Pads (Front & Rear)
General
Factory Hugger Orange Paint
Tan Leather Interior
T-Tops
SLP Ultra-Z Ram Air Hood
- Custom Painted Hugger Orange w/ “Ram Air” & Black Stripes
SLP Bow Tie Grill
Rear Light Panel Custom Painted Black
Factory A/C & Power Steering
46,000 miles
6-point Bolt-in CM Roll Bar w/ Dual Swing-out (not installed)
#12
#14
TECH Fanatic
iTrader: (2)
Join Date: Nov 2001
Location: Baton Rouge
Posts: 1,894
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by dragracefever
Still Looking....Ready to Buy!!!
Just posted mine up with the pics.
https://ls1tech.com/forums/vehicles-sale-lsx-powered-only/576781-fs-1999-hugger-orange-z28-600-na-horsepower.html
Paul
#17
TECH Regular
Join Date: Jul 2002
Location: Essexville,MI
Posts: 403
Likes: 0
Received 0 Likes
on
0 Posts
#20
On The Tree
iTrader: (18)
Join Date: Dec 2005
Location: Indianapolis, Indiana
Posts: 159
Likes: 0
Received 0 Likes
on
0 Posts
Check out my friend’s car; it is an all option 2000 Z28. It ran a 12.27 on an un-prepped track. If you head cam this car or spray on it you can easily have a 10 second car. It is a very straight “stock” car. He is looking to get $11,500. This is a good price for a great car.
https://ls1tech.com/forums/vehicles-sale-lsx-powered-only/575229-2000-z28-a4-stall-bolt-ons.html
https://ls1tech.com/forums/vehicles-sale-lsx-powered-only/575229-2000-z28-a4-stall-bolt-ons.html