LS1Adam84

iTrader: (21)

Some small things needed to be fixed on my tune and Ryne got it done for me. Car runs great now, I just need to do a rebuild on the rear end. Thank you Ryne.

0235SS

iTrader: (23)

yo Adam, are you guys going to irwindale this coming thursday?

LS1Adam84

iTrader: (21)

I believe so, my fiance is bugging me and asking if we are going since she misses it too lol

0235SS

iTrader: (23)

haha cool, i wanna go and check it out.

LS1Adam84

iTrader: (21)

Alright well I will PM ya my number hit me up if you go, typically we go then hit up BJ's brewhouse afterwards since there is one like 2 miles north west of the track.

XpEdItIoUs

iTrader: (44)

Nice Adam, now it's time for a sick *** 454 lsx 106mm turbo setup?

ZexGX

iTrader: (28)

Hey Adam, hit me up when you finally get the tools to replace the bearings.

patchz28

Good choice on CMS. I only trust them with my Hailey. Just got her back 3 weeks ago with a Procharger and other work.

LS1Adam84

iTrader: (21)

I only trust Ryne with tuning my car, I have had nothing but great service from him and sometimes little Mikey lol. I still do my own work on other things but he knows what he is doing with these tunes.

LS1Adam84

iTrader: (21)

I am thinking of making my own axle bearing removal tool, I will share once I get to it.


Ivan that would be nice but I am not made of money lol, I would love to have that setup haha.

XpEdItIoUs

iTrader: (44)

You can rent those from autozone for free. I used their bearing puller when I built a 8.8 for my SVO and worked like a charm. I have a race driver if your going to replace the pinion bearings. and I have a dial-type inch lbs torque wrench to set the pinion bearing preload.

LS1Adam84

iTrader: (21)

I was going to get a ling piece of steel bar stalk from home depot long enough to come from the other side of the axle you are working on and making a screw in piece that is small enough to fit in the axle tube and large enough to press against the bearing to hammer the sucker out lol.

I will draw a picture if needed but I see it in my head lol.

SS MPSTR

iTrader: (1)

Great work at CMS. Congrats on your experience.

henry172

iTrader: (2)

I can't wait to have my lt1 24x tuned by cms; the motor runs a lot better now even with just a blind base tune from Ryne.