Little_dan04

Soo Im Thinking About Tryin Out The New Toyo Proxies Tq's Drag Radials.. And I Seen They Make It In A 275/45R16..First Off Im Just Wondering If They Would Fit On The Stock Wheel And Then Second If There Gona Rub On Inner Fender Well... Hit The Bump Stop Or Anything.. Soo If Anyone Could Help Me Out That Be Great

Thanks
-Dan

cmaxw640

Stock 16's no... I would think the biggest you can throw on there is a 255.. they have 8.5 inch rim.

ABA383

iTrader: (1)

If it helps I ran the M&H DRs in the 275 55 R16 size on my stock 16s and they fit/worked great. They measured 28x9 and didn't rub anywhere...I don't know the dimensions of the Toyos, but I'd assume that they are a hair shorter than the M&Hs seeing as they run a 45 series aspect ratio rather than a 55...

--Alan

Little_dan04

The 275/45R16 Is 25.8" Tall.. And 10.8" Wide... Did You Have To Use A Wheel Spacer Or Take The Bump Stops Off At All Alan??

ABA383

iTrader: (1)

Nope, just mounted them on my stockers and bolted them up...I do have adjustable lcas and had previously squared the rear under the car and centered the wheels in the wheel wells, but the only issue I may have had if I didnt have the adjustable stuff was because they were 28" tall....At 26" tall you should be fine...

--Alan

Little_dan04

kkk.. Sounds Good.. Yeah I Have Adjustable Lower Control Arms And Pan Hard Bar.. Soo If It Is All Funny Lookin I'll Just Move Stuff Around... Thanks For All The Help.. Im Prolly Going To Order The Tires With In The Next Few Days Or Soo...