When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
mateo your ss looks great with those wheels,bramlock, i know its a stock wing,was just never a fan of them, ride looks good though , but mateo love the wheels on there much props to you sir
Thanks for the compliments guys. It was a lot of work too get em on and have minimal rubbing. It woulda sucked if you guys would of said theyr ugly after all that lol
Yea man I thought I was goin to have to put the stocks springs back n it because of the rubbing but that bfh comes in handy lol. Oh and thanks food nd cars!
It's nice to see those on a drop top, I've heard some say that you can't have even 11in wide on rear of one, but both of my cars look exactly like any other fbody inner fender.
i actually own a set of oem c6z wheels now, got them cheap. they look awesome except for the fact the tire sizes arent very good. i have 285/35 front...and 305/30 rears....
as far as fitment...awesome! i dont think they stick out too far, i trimmed up the bumpstop but didnt remove it....YET! but i will. and ill find some better tires someday...
I have the same rims and getting 245/40/18's for the front and 305/35/19's for the rear either tomorrow or Saturday.
325/30s and 275/35s no BFH ( ) mods required. This is just using 12-15mm spacers, rolled/pulled/flared/stretched quarters and an adjustable PHB out back to square everything up. I can probably fit more tire (10-20mm) without an issue either. Bump stops are still in place.
My turn!! This thread right here was the reason for my purchase of these wheels lol,I love the look they gave my car,lots of work to get them to fit with no rubbing but very much worth it! My setup is nitto nt05 335/30 rears 285/30 fronts,no spacers,LOTS of BFH'ing no doubt tho,enjoy..
Bringing this post back up from the dead here’s my 2000 trans am oem z06 wheels 19x12 out back with 325s. BFH rolled fenders all umi suspension components 2” lowering springs no issues or running I will be adding 6mm spacers in rear though just for piece of mind it’s close lol
You know I was just thinking about these wheels for my '99 SS and here we are. I think I'm going to grab a set and run 325's on the rear. I have +36 offset ZR1 wheels with all the necessary suspension upgrades and I got them to fit quite nicely.
But I'm sure the black Z06's with 325's will be so much better.
12-19-2011, 01:53 PM
) mods required. This is just using 12-15mm spacers, rolled/pulled/flared/stretched quarters and an adjustable PHB out back to square everything up. I can probably fit more tire (10-20mm) without an issue either. Bump stops are still in place. 
[/IMG]
[/IMG]
