Prostars on a 5/8ths wheel stud
#1
TECH Enthusiast
Thread Starter
iTrader: (22)
Join Date: May 2007
Location: DFW, Tx
Posts: 739
Likes: 0
Received 0 Likes
on
0 Posts
Prostars on a 5/8ths wheel stud
Im running the 5/8ths studs and getting a set of prostars for slicks. Im currently running a holeshot wheel which is much thinner than a weld prostar. So this is going to impact my alumnimum spacer that goes on the back of the nut, it will need to be smaller for the for the prostars.
Does anyone happen to run this setup and know how thick the aluminum spacer for prostars should be?
Does anyone happen to run this setup and know how thick the aluminum spacer for prostars should be?