ws6turbo

Deep dish rims that I can run without the BFH mod or rolling fenders.

Car is white ws6, , any suggestions or maybe pics on a car? I like the dd c5 wheels but again dint wanna bang on the car over rims.. unless I have to.. I'm lowerd 1.25 inch I believe. .

Furious1

iTrader: (1)

Its going to be hard without a little inner wheel well massaging. I run CCW's with a 3" lip.

ws6turbo

Sweet car.. I was thinkin of running some tt2 rims .. I see you removed the lettering and trim like I did.. that's how they shoulda came anyway.. so u had to BFH the wells?

Furious1

iTrader: (1)

I also have TTII's, and did not have to do anything to clearance those. For the CCW's, I needed to bang the inner fender a bit. Its not that bad.

Rise of the Phoenix

iTrader: (27)

OP, don't be afraid of doing the BFH mod. Typically, the only part that needs "massaging" is the inner part of the fender that's toward the front of the car; not the rear part of the inner fender. What I did was got about a 6 pack in me, got the courage to do it, and once I was finished and had the wheels on there, didn't look back. I also spray painted the entire inner fender section flat black so you couldn't tell where the hammering took place.

LS69TA

iTrader: (30)

The BFH mod is always good, but if I ever get another 4th Gen, I'm narrowing the rear a few inches and mini-tubbing.