poorhousenext

New best ET at Chevy Performance Nationals, Atlanta Dragway, Commerce, GA



Car as ran was around 20-25 LBS heavier as it had a little over a 1/2 tank of gas.

Previous best was 11.97 @ 117.20; 2.005 60' at 2014 LS Fest. Car weight 3564LB with driver and less than 1/4 tank of gas.

DA had to have been better.

Engine is GM crate LS3 HO 480HP. 3.55 Rear Gear, TCI 6x trans, Converter about stock stall, and Nitto 555 300 Treadwear tires, no DR or Slicks. Car has 52% of weight on rear tires and 48% of front. No Line Lock so no burnout, drive around water box, stage and go, when I realize light is Green...



Pick up 52 Shetland ponies when Dyno'ed on a Dynojet. Intake is restrictive so that hurts power numbers.

BODUKE

Good runs and a sweet car.

HCI2000SS

iTrader: (2)

Very nice car! Hard to read, but did it make 391 rwhp?

poorhousenext

There are 2 engines overlaid'ed on same sheet. LS7 (RED Line) which made 391 RWHP and 370 RWTQ with LS2 MAF I've pulled out of car below, to go in current project that I'm going to try and go 10's in 1/4, with less than 400 RWHP, on minimum of 200 Treadwear street tires, no DR's or slicks. Use LS2 MAF and Mustang Dyno to get LS7 engine under 400 RWHP...LOL

LS3 HO (Blue Line) 357 RWHP, 348 RWTQ. LS3/7 MAF.



Rendering of project.





PS: I'm 71, living proof there are only to kind of men, Young & Dumb and Old & Stupid...

scotty2000ss

iTrader: (2)

Nice job! Car is movin!

sabersaw30

iTrader: (10)

1.6 60ft should get you in the tens are real close