LS1TECH - Camaro and Firebird Forum Discussion

LS1TECH - Camaro and Firebird Forum Discussion (https://ls1tech.com/forums/)
-   12 Second Club (https://ls1tech.com/forums/12-second-club-86/)
-   -   Stock stall 2.73 car first 12 (https://ls1tech.com/forums/12-second-club/1850390-stock-stall-2-73-car-first-12-a.html)

Freshsqueezd 11-01-2016 01:21 PM

Stock stall 2.73 car first 12
 
car is a 01 z28 with headers true duals slp lid and ported tb on Mt drag radials (they made the car slower) https://cimg5.ibsrv.net/gimg/ls1tech...9ed6be6bf7.jpghttps://cimg9.ibsrv.net/gimg/ls1tech...227eafeff3.jpg

ironmikektm525 11-01-2016 03:34 PM

Good run! What was da?

spicebird98 11-01-2016 07:21 PM

U don't need those mickeys with the power level and gearing you have, they way a ton. We went 12.4 at 113 with basic bolt ons stock stall. Keep working at it

fastsspr 11-01-2016 10:29 PM

What altitude above sea level is the track? The car is tunned?

Freshsqueezd 11-02-2016 08:06 AM

Track is 74ft above sea level it was really good air not sure on da but the car has a frost tune and believe me I kno I don't need the drs they slowed the car up a good bit I got a 3.42 rear for $200 I'm gonna swap that in and see if that makes up for the tires until I can finish saving for my stall

Freshsqueezd 11-02-2016 08:09 AM


Originally Posted by spicebird98 (Post 19441763)
U don't need those mickeys with the power level and gearing you have, they way a ton. We went 12.4 at 113 with basic bolt ons stock stall. Keep working at it

I'd love to see a 12.4 what was the setup if you don't mind me asking?

spicebird98 11-02-2016 09:52 PM


Originally Posted by Freshsqueezd (Post 19442155)
I'd love to see a 12.4 what was the setup if you don't mind me asking?

Sure, it was a Lid, Super sucker ram air duct, bbk 1 3/4 mid length headers, catted bbk y pipe, hooker catback, toyo TQ drag radials on stock wheels. Bone stock suspension but removed front sway bar. Best with 2.73's was a 12.49 with a 1.90 60', switched to 3.42's and went 12.42 with a 1.87 60' if I remember right. Full weight t top/leather car with the spare tire removed.

Freshsqueezd 11-03-2016 08:23 AM

I wish i could see a 60" in the low 1.9s or high 1.8s the mickeys are killing me for sure car bogs like crap that 12.96 pass the car was actually spinning tho I aired em up to 35 to try to help with the bog and drove around the water box and just did a dry hop best 60 with the car was a 1.99 but that was the cars worst pass too dead hooked but took a while to get the rpms back up

ironmikektm525 11-03-2016 03:48 PM


Originally Posted by spicebird98 (Post 19442979)
Sure, it was a Lid, Super sucker ram air duct, bbk 1 3/4 mid length headers, catted bbk y pipe, hooker catback, toyo TQ drag radials on stock wheels. Bone stock suspension but removed front sway bar. Best with 2.73's was a 12.49 with a 1.90 60', switched to 3.42's and went 12.42 with a 1.87 60' if I remember right. Full weight t top/leather car with the spare tire removed.

Strong run for not even full boltons! Must of had some good da.

murphinator 11-03-2016 07:35 PM


Originally Posted by Freshsqueezd (Post 19443202)
I wish i could see a 60" in the low 1.9s or high 1.8s the mickeys are killing me for sure car bogs like crap that 12.96 pass the car was actually spinning tho I aired em up to 35 to try to help with the bog and drove around the water box and just did a dry hop best 60 with the car was a 1.99 but that was the cars worst pass too dead hooked but took a while to get the rpms back up

are you mashing it off idle to get the most "flash" out of the convertor ? or are you preloading it/brakestanding ?

Freshsqueezd 11-03-2016 09:06 PM


Originally Posted by murphinator (Post 19443886)
are you mashing it off idle to get the most "flash" out of the convertor ? or are you preloading it/brakestanding ?

I was leaving off idle/flashing its slower off brake stalling it went a 13.05 brake stalling with a 2.00 60ft

Freshsqueezd 11-28-2016 05:12 AM

New pb guys
 
I just matched spicebirds 12.42 last night with just a 3.42 gear change other than that everything is the exact same
https://cimg1.ibsrv.net/gimg/ls1tech...54e1786ac7.jpg

I was in the left lane it was a freakin Chrysler crossfire in the right lane I barely held him off

Freshsqueezd 11-28-2016 05:13 AM


Originally Posted by Freshsqueezd (Post 19443966)
I was leaving off idle/flashing its slower off brake stalling it went a 13.05 brake stalling with a 2.00 60ft

I leave off idle that's how I get my best ets

rybern 11-28-2016 07:49 AM

Very impressive times with those mods.... especially with stock converter. I couldn't get below 13.0 with the stock converter(n/a and stock cam).

murphinator 11-28-2016 08:29 PM

nice job , picking up a good 4k stall should have you around 11.9/12.0 in similar racing weather

sillysspeed 11-28-2016 08:37 PM

Nice times! Stock converters leave a lot to be desired for sure. My best 60ft was 1.88 with it. Felt like it took forever to crack 1.99 and faster 60ft.

jhshnh 11-28-2016 10:04 PM

Very nice. I went 12.89 with stock stall and 2.73s. I went with et streets and 4k stall and went 12.29 with stock gears still.


All times are GMT -5. The time now is 08:30 AM.


© 2024 MH Sub I, LLC dba Internet Brands