Bolt on WS6 joining the club
 

Car has full exhaust, tune, tire, lca, Cai pretty basic set up mods in sig I put down 350/365 on a dynojet any how only made one pass previous best of 13.3 at 105 ran a 12.7 last night at q09.8 da was 1562!
https://cimg0.ibsrv.net/gimg/ls1tech...d9f08b9cb7.jpg

https://cimg2.ibsrv.net/gimg/ls1tech...d6851a7e6b.jpg

nice job , should go 12.5 with better DA.

you list "tire" under mods but your 60 foots are in the 1.9s is this an M6 car or an auto ? assuming no stall if yes.

your trap of approx. 110 shows the car has low 12's capability in the 1500 ft da you ran in if you can tighten that 60 foot up.

Yes I have a drag radial,car is M6 launched at 3500 rpm and it hooked up well but bogged on the launch all my other shifts were clean if I would of run again I think 4000 would of worked great and I could of cut a better 60 foot time, I did feel like the car had a couple of tenths to be had from the launch...

Murph is right, there is a lot left in it and you will have a blast as your 60's come down. Your car has 1.7x 60's in it if your DR's can hold. Launching a manual car is where the fun is.

Hope to see you out at RPR this Friday.

I'll try launch it up at 4000 rpm should help keep it up in the power band..... cant go to RPR until begining of December to much going on. But ill be there soon enough!! You really think low 12's huh? I would be happy with a 12.5.:burn:

my bolt on M6 car made 11.9 on a 111 trap for previous owner , I watched him run it that night and snatched it up when it came up for sale lol