just another little job turned into a project...
 

went to change water pump on my engine, and ended up cleaning up some stuff... polishing fuel rail and valve covers, will have better pics when i finish them...i wish they just made nice valve covers for my car...

http://i829.photobucket.com/albums/z...-41-45_540.jpg
http://i829.photobucket.com/albums/z...-42-35_980.jpg
http://i829.photobucket.com/albums/z...-08-43_270.jpg
http://i829.photobucket.com/albums/z...-42-11_382.jpg
http://i829.photobucket.com/albums/z...-48-29_115.jpg


just tried one spot in valve cover, looks like itll end up pretty nice, just like 1000 hours to go lol

http://i829.photobucket.com/albums/z...-12-17_592.jpg

looking really good so far, will definitly be worth it at the end.

thanks yea i hope soo..

Great job man

I hate polishing but the end result is always worth it.

what did you use

Looks nice! X2 on what you used?? Its comin along good

Im doing the covers on my LQ9 swap... Im walnut blasting mine first then polishing with the bench grinder/wheel... yours look good so far man..

damn that looks good how are you doing it?

I would assume you are just using a buffing wheel and some polishing compound right? If not I'm curious as well. Either way it looks really good so far.

thanks for comments..on my fuel rail i used green scotch bright pad to get the black coating off, then maroon scotch bright pad to smooth out scratches, 800-2000 sandpaper.. then a powerball and mothers aluminum polish... on fuel rail mounts and valve covers. im using 400 sandpaper the get smoothed out and same process as above... im not a pro at polishing shit and there is prolly easier ways to do this but jus using shit i have laying around the garage..