who281

iTrader: (1)

...how do i remove the yellow turn signals in the front of my camaro??


thanks

UAZ28SS

iTrader: (2)

You can go in from underneath, or you can pull the headlights and get to them from up top.

Y2K Pewter SS

iTrader: (18)

I always pull my headlights and do it from the top. There are 3(7 or 8MM) screws to remove so you can get the turnsignals out. Be careful not to scuff your paint as you manuever the turnsignals getting them out.

SSinisterTX

iTrader: (2)

u'll get them out by wiggling them around, it will take a while....

daryl2cb@yahoo.com

iTrader: (2)

I also used a dremel cut off wheel, to slightly grind the fender/bumper support bracket, this most likely will hold you up.

smg267

iTrader: (23)

Pull the headlights! There is only one screw holding them on in the back. I too was stumped when I got my clear corners. Pull the screw out and push the headlights in towards the center. You might have to put a little muscle in. Don't be scared.lol THe turnsignals are a bitch! The stupid middle bolt holding them in is a pain. These are just trial and error sliding them out. Def watch out for the paint. I didn't put the center bolt back in when i reinstalled my new corners just so it is easier if I ever need to take them off again.