LT4hotcam

i put it in reverse and it wont go, so i had to put it in neutral and push it out of the parking space. then i put it in drive and it drives like normal and has all gears. Can anyone help me out.

WS SIKZ

iTrader: (3)

if its in reverse and you rev it high and it starts inching back , most likely its the reverse clutches check the trans oil and if its purplish brown most likely you need to get it rebuilt

performabuilt

iTrader: (25)

No reverse would be a mechanical issue like mentioned its it was sudden I have seen the LOW/REVERSE piston and the REVERSE INPUT drum piston crack and cause this. But your definatly gonna be rebuilding or replacing

GT Griller

iTrader: (8)

U better take that **** back to fergusson or get ur money back and take it to Richard, u know he will do it right.

LT4hotcam

Its allready at his shop.

GT Griller

iTrader: (8)

SUcks to hear chris...hope he fixes it tho.

LT4hotcam

i kno and i was planing on going to the track this weekend and running it to.

LT4hotcam

I found out what happened, the teeth broke in the shell, has that ever happenede to any one, i have to get a whole new shell.

performabuilt

iTrader: (25)

Well if it was a built trans It should the beast shell with your setup , I have never seen a beast strip the teeth out. If it didn't have one thats what you should replace with, And why are you buying it I would think that would be under warranty. Or is it a labor only warranty no hard parts I have seen some written that way.

BlackZ28629

iTrader: (8)

interesting... my reverse is doing the same...rev high then pulls... I have a beast sun shell though..its prob. something we missed when putting the new input drum in...

performabuilt

iTrader: (25)

Yes if you move at all in reverse even reved then its would not likely be th shell

GT Griller

iTrader: (8)

I agree.....if fergussen "built" u the tranny the sunshell should have been replaced....i think he gave u a stock rebuild with a shift kit.

LT4hotcam

the sunshell was okay, thats what he thought had messed up the reverse. He showed me the sunshell, it was fine.

GT Griller

iTrader: (8)

sssssssssssssssss...so what was it fool?

LT4hotcam

The teeth on the inside of the case were all the gears go, inside the tranny.

performabuilt

iTrader: (25)

You mean the lugs on the inside of case where the low/center support goes completely stripped, WOW haven't seen that , I have seen then worn badly but broken all the way around though no.

GT Griller

iTrader: (8)

Damn that sucks.....ask Carlos tranny #4 did that on him....lol

LT4hotcam

Yah thats what happened. It does suck

armyracer11

iTrader: (7)

I have seen that before, at the bottom where the sprag goes? It usaly means they didnt put the case saver (the little spring) in all the way or in at all.

LT4hotcam

He went ahead and put the beast shell in there and took out the sun shell.