Flex Fuel Sensor for the Gen I V
#1
Flex Fuel Sensor for the Gen I V
Does anyone make a flex fuel sensor for the Gen I V? I'd like to run corn as the meth injection just isn't giving me the timing increases I expected. TIA
#4
Check with Jeremy Formato, I think his company is FasterProms. he is a very good tuner and does a lot of this. yep, here
https://fasterpromsstore.com/product...5-flexfuel-kit
https://fasterpromsstore.com/product...5-flexfuel-kit
I can't get the link to work. It does a password challenge and then bombs out with a 'something went wrong..." message.
#6
Ouch. That's a lot of segment swaps. I have not done one to date.
THANKS for the info. I will take a closer look at this. The pinout they refer to in the text must be for the LS6 (makes since with the 2005 Silverado segment swaps). I have the LS2 w E67 PCM. Pin 56 on C1 is used for the starter relay. They likely have a different pinout and hopefully a different Silverado tune to use as well (the tune in our E67 seems to be an SOB as it is not similar to much of anything that I have found). Better yet maybe the flex fuel tables are enabled in the E67 (06 07 V) tune.
THANKS for the info. I will take a closer look at this. The pinout they refer to in the text must be for the LS6 (makes since with the 2005 Silverado segment swaps). I have the LS2 w E67 PCM. Pin 56 on C1 is used for the starter relay. They likely have a different pinout and hopefully a different Silverado tune to use as well (the tune in our E67 seems to be an SOB as it is not similar to much of anything that I have found). Better yet maybe the flex fuel tables are enabled in the E67 (06 07 V) tune.
#7
On The Tree
Advanced Fuel Dynamics has a plug and play system for the C6 (LS2) Vette and C5 (LS1/6) Vettes. Not sure if the connectors/connections would be any different between them and our V's or just the wiring lengths/install instructions.