Shark Gray 2000 SS build
The following users liked this post:
LaBLKv6Z (06-16-2021)
#309
TECH Fanatic
Thread Starter
iTrader: (13)
The two cams are similar, I wanted more duration and lift. Even with the rocker ratio factor decrease from the cam card, the intake and exhaust duration is increased quite a bit from the cam I was running.
The following users liked this post:
00pooterSS (12-11-2019)
#312
TECH Fanatic
Thread Starter
iTrader: (13)
Measured and ordered new push rods. I'm needing 7.550" long push rods for .035" preload on my Johnson reduced travel race lifters. Went with 3/8".
Also started disassembling the suspension off of the kmember. Plan to drop the kmember from the engine next.
Also started disassembling the suspension off of the kmember. Plan to drop the kmember from the engine next.
The following users liked this post:
AINT SKEERED (12-16-2019)
The following users liked this post:
AINT SKEERED (12-16-2019)
#317
Very nice build , I just moved to Pine Prarie, from Thibodaux a year ago or so. When you get a chance can you shoot me some info on car meets in the Lafayette area.
Thanks, Happy Holidays !!
Thanks, Happy Holidays !!