Dynotech mustang ls swap headers
#2
12 Second Club
iTrader: (3)
Join Date: Apr 2006
Location: NW INDIANA
Posts: 170
Likes: 0
Received 0 Likes
on
0 Posts
We have a set on a car we are building now they fit great with the AJE K member. The only thing I wish they would have done is make the collector a little lower as the exhaust will run right into the cross member on the drivers side and is very very close to the shifter bracket on the trans.
#4
TECH Regular
iTrader: (33)
Join Date: Feb 2003
Location: Illinois
Posts: 456
Likes: 0
Received 0 Likes
on
0 Posts
My Kooks headers were VERY close to the steering shaft and the drivers side header was a few inches from the trans crossmember. I dont think I could have ran exhaust without extensive modifications.
Trending Topics
#8
On The Tree
One thing I have noticed on the Kooks headers is, they leave a good bit of length on the collector. This could be cut back a few inches i'm sure which leaves more room for the transition towards the humps in the tranny cross member.
I have long tube headers on my 5.0 mustang and the drivers side collector points right at the transmission cross member bracket.
I have long tube headers on my 5.0 mustang and the drivers side collector points right at the transmission cross member bracket.