dieselcharged

iTrader: (1)

I have an 04' 5.3 that I am putting into first gen S-10 which has a fly by wire setup and going to run a cable setup does anyone know what has to be done. Thanks

rojs234

iTrader: (5)

Go to www.lt1swap.com. He has instructions to walk you through it step by step. A young friend and I are doing pretty much the same thing , only we are putting the 5.3 in a '51 Ford pickup. I was really dreading trying to rework the factory harness, but thanks to this website, I'm almost done with it. Good luck! Ron

jbal

The other option is to get one from eBay for $450 and focus on other aspects of the project. Sell your factory harness tohelp pay for the new one.

spartanv8

iTrader: (4)

http://www.lt1swap.com/2004vortec_pcm.htm

http://www.thirdgen.org/techboard/lt...rt-finish.html

I'm using the same harness. Used the above 2 sites to take it all the way apart, now have to put it back together.. Here's my thread, might help: https://ls1tech.com/forums/conversio...-together.html

Jesse

71 chevelle

iTrader: (13)

Good info. I like the fact that lt1swap has all the info listed or will do it for you. I think I will use him.

twisselman1968

iTrader: (1)

its hard to beat mr patten and lt1swap.com I keep using him and I think I'm happier each time