BAN-LS1

iTrader: (16)

So after looking for a long time for headers for my 77 TA I finally found that Edelbrock has headers for the 2nd gen f-body LS1. They say you have to use their motor mounts but I have the 1st design BRP kit. The headers fit great with plenty of clearance all around. at $519 stainless coated no complaints here.

1968-72 GM A-Body, 1970-81 GM F-Body and 1975-79 X-Body with LS Series V8 conversion headers (1-3/4", stepped to 1-7/8", 3-1/2" collector) #65073

jmarsa

iTrader: (1)

Looks like a good product. Thinking of using them myself.

--JMarsa

zamora7

iTrader: (4)

Wow! Looking good, I'm hoping my 80 T/A will look the same in a few months. I may have a few questions for you when I get going with motor installation and such.

BanditDave

iTrader: (11)

Looking good man! I did this swap a while back but used BRP's kit...what a CF!!!

Their headers don't fit for ****!!! I had to trim a lot to get the kit to fit and since my car is heavily lowered it doesn't give me ANY ground clearance.

I was wondering what pan you used and did you lower your car at all?

Thanks!
Dave

BAN-LS1

iTrader: (16)

01 Foby pan

mantycarguy

Great looking project. Who makes the fuel injection setup that you are using? I am looking at running the same type of system. Is this a kit from one company or is it a combination of many different manufacturers?